Keep electronics in your enclosure from getting too hot or cold with these thermostats that control two devices at once.

Set to actuate at a specific temperature, these switches are easy to setup and prevent changes to the setpoint. They have a threaded probe, so they install directly into tanks, pipelines, and other process components to turn equipment on and off at a set temperature.

Install the threaded probe directly into tanks, pipelines, and other process components to turn heating equipment on or off at a specified temperature.

Often used in hazardous locations, such as chemical plants, refineries, and grain elevators, these switches have a housing that’s UL listed for environments with flammable gases, combustible dust, and ignitable fibers.

To protect these switches from splashing water, corrosive liquid, and dust, the housing meets NEMA 4X for washdown conditions.

Often used to control heat cable output, these switches maintain your surface’s temperature by turning equipment on or off when they reach a set temperature.

The faceplate on these controllers is sealed to meet NEMA 4X and IP66 for protection in washdown environments with splashing water, corrosive liquid, and dust.

For protection in washdown conditions with splashing water, corrosive liquid, and dust, these controllers have a wall-mount housing that meets NEMA 4X. They’re ideal for systems with rapid, unpredictable, or complex temperature changes.

Built into an enclosure, these temperature controllers are protected when sitting on your workbench. They turn heating equipment on and off using a proportional-integral-derivative (PID) control algorithm to make fine adjustments, giving you the most precise and stable temperature control.

The simplest temperature controllers—they turn devices fully on or off, with no middle state, at a given temperature.

Switch heaters on or off when your process reaches a certain temperature. Both these controllers and your heater will be powered by the same wall outlet.