Light up large, open rooms where you need a quick setup and takedown, such as a room under construction. Just hang these lights from a ceiling up to 30' high and they’re ready to go.

Hang a string of lights overhead to brighten wet jobsites. IP rated, these lights are sealed to keep out dust and moisture from washdowns, splashes, and sprays, even outdoors.

A flexible design allows these lights to be suspended above, wrapped around, or routed through areas on the job site.

Hang these lights above your workspace—they shine through long tubes to distribute even light with minimal glare and shadows. Carry them where you need them and suspend them from pipes, beams, and other overhead surfaces.

Pop these lights on magnetic surfaces to brighten wet spaces. Rated NEMA 6 and ETL listed, you can splash, spray, or dunk them in water, and they’ll keep working.

Power these lights with the same battery as your other cordless tools. They run on a Milwaukee M18 battery to light up work where there’s no outlet.

Aim light where it's needed most in areas that don't have an electrical outlet.

From pipes to pallet racks to control panels—these lights clamp onto almost anything and swivel to direct light just where you need it.

Aim light where you need it—even in explosion-prone spaces—by raising, lowering, and tilting these lights on their tripod. Rated NEC Classes I, II, III, and Zone 0, they’re safe to use near ignitable concentrations of flammable or combustible gas, dust, or fibers.

Bring light to explosion-prone work areas. Rated NEC Class I, these lights are safe to use in areas with ignitable concentrations of flammable or combustible gases, vapors, and liquids.

Brighten remote areas using the same battery as your other cordless Milwaukee tools.

Flood dark, remote jobsites with multiple tiers of light. These cordless lights stack on top of each other to focus a strong beam of light in one direction.

Compact and easy to carry, these ETL listed lights stand up to dripping, splashing, and falling liquids. The head adjusts up and down to direct light where it's needed.

Raise, lower, and tilt these lights to brighten your work in wet spaces.

Brighten areas of a jobsite with these floodlights, and move them at a moment’s notice.

Brighten remote spaces with the DeWalt rechargeable battery that’s already in your toolkit. These floodlights extend up to 7 ft., and the light head turns at any angle to aim light where it’s needed.

When the power goes out, these flashlights automatically light up. The head tilts so you can aim light wherever you need it.

Slip these penlights into your pocket to always have a flashlight on hand.

Shine light into hard-to-reach spaces with these flexible-arm flashlights.

Clip these little flashlights to a baseball cap or a surface to light up your work.

IP rated for submersion, these flashlights keep working even if dropped in water. They run on a rechargeable battery, saving you the hassle of frequent battery swaps.

Always have a light handy. These flashlights use disposable batteries, so you can swap in a new set at any time without waiting for a charge.

Light up objects more than a quarter of a mile away. These flashlights are also known as searchlights.

Rated IP07, you can drop these penlights in water and they’ll still work. Plus, they’re small enough to fit in your pocket.

Shine light into hard-to-reach spaces—these flashlights have a flexible arm to see around tight corners and in crevices. They’re rated for use in environments where flammable gases, vapors, and liquids are present.

Clip these little flashlights to any surface up to 1/2” thick and keep your hands free for work. They’re rated for use in environments where ignitable concentrations of flammable or combustible gases, vapors, and liquids are present.

Illuminate small spaces and mark locations with these reusable lightsticks.

Light up work even when your visor is up. These headlamps come with three attachments that fit with anything from your hard hat to your baseball cap.

Light up work while staying visible in high-risk areas. These headlamps have LEDs on the head band so forklift and truck drivers can see you.

Light up work without risking an explosion. NEC rated, these headlamps are safe to use in areas with ignitable concentrations of flammable or combustible gases, vapors, and liquids.