Also known as Allen nuts, use these with socket head cap screws in recessed holes and tight spaces that don't have enough clearance for a wrench. Tighten them with a 6-point hex key. They can also be used as an insert by pressing or drawing them into nonhardened steel, cast iron, or soft nonferrous metal or by molding them into plastic, ceramic, fiber, and similar materials. Made from alloy steel, they're comparable in strength to Grade 9 bolts.

Smoothly install these inserts for strong threads near the edges and corners of soft metal surfaces. They’re lubricated to prevent sticking as you thread them in. Since these have thinner walls than our key-locking and thread-locking inserts, they don’t need as much space and won't bulge or crack the material. The knurls press (swage) into the material to keep inserts in place when you tighten or loosen a screw.

To install these inserts, you need a drill bit, a counterbore, a standard tap, an installation tool, and a hammer. Drill a hole, counterbore the top, and tap it. Place the insert into the installation tool, then hand-tighten it into the tapped hole. Strike the tool to secure the insert and drive the knurls into the surrounding material.

Align threads with off-center parts. These inserts have floating threads that shift slightly so you can insert screws at a slight angle as you fasten two parts together. They're comparable to Keensert inserts.

To install, drill and tap a hole in your material. Then, thread the insert onto the installation tool and screw it into the hole. Place the tool over the keys and hit it with a hammer to drive them in.