Push and release the button to activate—no electricity required.

Control two devices and delay the shut off of one device by up to one hour. These switches are often used with lights and fans for ventilation.

Control equipment with high currents such as air conditioners, heaters, and ventilation fans.

Install these switches in a panel cutout.

Mount these switches to a flat surface or attach to DIN rail.

Install these switches in a panel cutout.

Use your smart phone to turn equipment on and off at a set time and day.

Control equipment with high currents, such as landscape lighting, pumps, and heaters.

Rated NEMA 3R, these rain-tight switches protect against falling liquids and light splashing.

Attach these relays to a flat surface using the mounting hole. They have no moving parts, so compared to mechanical switches, they require less maintenance, last longer, and are quieter.

Reduce voltage fluctuations and stress on shafts and bearings when starting up three-phase motors. These timer relays start with motor contacts in a star configuration, then switch to a delta configuration after a set delay.

Install these relays in a panel cutout or plug them into a relay socket. Unlike mechanical relays, these solid state relays have no moving parts, so they require less maintenance and last longer, are quieter, and switch faster.

Considered solid state because they don’t have any moving parts, these timer relays last longer, switch faster, and are quieter than mechanical relays. They interface between your controller and components to isolate input and output circuits, preventing damage to your components from voltage spikes, amplifying the relay's signal, and reducing signal interference. They have multiple timing functions, so you don’t need to swap out your relay if you want to change their function.

Mount these timer relays directly to 35 mm DIN rail (also known as DIN 3 rail) for fast installation. Unlike mechanical relays, they have no moving parts, so they require less maintenance and last longer, are quieter, and switch faster.

Control two steps of an electrical process from a single relay—with two fully independent channels and 30 different functions, these relays give you a wide range of possibilities.

Combine the functionality of a PLC and the accessibility of a development board. Built around a Raspberry Pi and an Arduino-enabled microcontroller, these controllers use open-source software to make programming and troubleshooting convenient.