Overlapping abrasive flaps bonded to a backing plate provide consistent material removal and even finishes.

These discs have a harder abrasive than standard flap sanding discs.

The flaps alternate between an abrasive to remove material and a lubricant that minimizes heat to reduce discoloration of the work surface.

Replace your sanding discs less often—the backing plate on these discs can be trimmed off as the abrasive flaps wear down, allowing you to use more of the disc.

Set at an angle and widely spaced, the overlapping abrasive flaps reach into corners.

These discs have a harder abrasive than standard flap sanding discs.

Replace your sanding discs less often—the backing plate on these discs can be trimmed off as the abrasive flaps wear down, allowing you to use more of the disc.

The flaps wrap around the outer edge of these discs to sand welds at right angles.

A coating prevents dust and debris from building up on the abrasive surface.

The zirconia alumina grit on these discs continually fractures to produce new, sharp cutting edges that aggressively remove material from steel and wood.