Use one of these compact filters in a tight spot, or combine up to ten for a manifold application. Typically used on vacuum pumps, they ensure that clean air is going in and coming out of your system.

These filters have a clear housing so you can monitor collecting debris without stopping flow. Typically used on vacuum pumps, they ensure that clean air is going in and coming out of your system.

Install these filters between your high-vacuum chamber and the inlet of your pump to remove dust, water vapor, and other contaminants from the system and protect the pump. Commonly used in vacuum-furnace and coating applications, they have a polyester filter element that traps particles as small as 5 microns. All filters have been helium-leak tested to ensure quality. When the filter element becomes clogged, you can replace it.

Quick-clamp connections are also known as KF, QF, and NW connections; they require a ring and quick clamp (sold separately) to complete the connection.

Claw-clamp connections are also known as ISO-K connections; use a ring and multiple claw clamps (sold separately) to secure. Double-claw clamps attach to the grooves on the fittings. Single-claw clamps have a clamp on one end and an exposed bolt on the other. Thread the bolt-end directly into the body of pumps, valves, or other high-vacuum components.

Improve vacuum system efficiency and protect components from moisture—these separators remove over 90% of water from air. Typically used with vacuum pumps, they minimize vacuum pressure drop, even when the element is saturated with water. Separators have a viewing window so you can see inside to monitor water removal. Mount separator vertically for proper drainage (brackets sold separately), and install before air filters.

Capture oil, oil vapor, and other contaminants from your pump to prevent them from spreading into your high-vacuum system with these filters. When it's time to replace the filter element, you don't need tools to access it; undo the quick-release clamp to open the filter body. Filters have a drain port to remove collected oil.

Filters with quick-clamp connections (also known as KF, NW, and QF fittings) require a quick clamp and a ring (both sold separately) for each connection.

Filters with claw-clamp connections (also known as ISO-K fittings) will connect to larger components than filters with quick-clamp connections. Use four claw clamps and a ring (all sold separately) to secure each connection. Double-claw clamps attach to the grooves on the fittings. Single-claw clamps have a clamp on one end and an exposed bolt on the other. Thread the bolt-end directly into the body of pumps, valves, or other high-vacuum components.

With a threaded connection on both ends, these mufflers can be installed anywhere in your line. They are designed to minimize noise from rotary and centrifugal blowers, vacuum pumps, low-pressure vents, and other loud equipment with minimal pressure drop.