Two vise heads tilt and rotate 360°, locking in place to hold work at any angle. The arm holding the vise heads tilts 180°.

Free up a hand while using your Dremel on a workpiece. You can use these vises in three different ways: hold your Dremel to make it a stationary tool, secure your workpiece in the vise, or remove the clamp and use it on its own. These vises rotate 360° and tilt, so you can work on your project from any angle.

Rotate the head 360° to use three different vise jaws and lock workpieces in position at 45° intervals. The base also swivels 360° to move the entire vise and can be locked in place. In addition to flat jaws, these vises have two sets of V jaws (also known as pipe jaws) that securely grip pipe and other round objects.

Position your circuit board at a comfortable angle when attaching components. These vises rotate, so you can access the back of your board.

For large workpieces, these vises open three times as wide as industrial tilting-head vises. The head tilts, rotates, and locks in place to hold your work at an angle. Vises have one smooth jaw and one grooved jaw for clamping flat, round, and uneven workpieces. The 5-lb. weighted base is heavy enough to keep the vise in place but light enough to be portable. For temporary mounting, add a clamp-on base (sold separately).

Rotate these vises to solder both the front and back of your circuit board while preventing static charges from damaging your components. Plastic jaws slowly drain static charges away, minimizing the buildup of electrostatic discharge (ESD). To make soldering components through the holes on your board easier, these vises have a positioning arm that holds your component. This allows you to rotate the board and solder on the opposite side without you needing to hold the component.