Install and service setups for two, three, and five wires, then reuse these connectors later. They pop on and off wire with the flip of a clamp to save time over crimping. Choose them for setups that change often, such as prototypes and testing. They even have test sockets to safely test voltage after installation. The assortments include DIN-rail adapters so you can snap connectors into a control panel.

These connectors are as quick to install as our clamp-on option, though they're not as easy to adjust. They extend or terminate electrical connections in branch circuits, such as light fixtures and electronic devices. Push wire into place without the need for an installation tool. To break the connection later, you'll have to pull wire back out. The connectors also have test sockets to safely test voltage after installation.

Mounting Adapters—Clip connectors onto DIN 3 rail to keep them organized and easily accessible.

Covers—Seal out moisture to protect your connection. Covers are lined with a sticky gel, so you don't need to mix or pour a potting compound yourself. They’re rated IP08 to withstand splashes, rain, and humidity. To repair or expand your circuit, open the cover and remove the wires so you can reuse them. However, you'll need to replace the splice and cover after you open the cover and remove the gel.

Seal out dust and moisture to protect splices, terminals, and other electrical connectors. These covers are lined with a sticky gel that encapsulates the electrical connector. The seal created by the gel helps them meet IP08 standards—use them in junction boxes and outlets exposed to high humidity, rain, and splashing water. Unlike potting compounds, you don't need to mix or pour the gel before you install these covers.

If you have to expand or repair a circuit, you can open these covers and use the wires again. However, once you open the cover and remove the gel, you’ll need a new electrical connector and cover.

Install and service setups for two to eight wires. These assortments include DIN-rail adapters so you can snap connectors into a control panel. Quick-connect push-on connectors are as fast to install as our clamp-on option, though they're not as easy to adjust. Push wire into place without the need for an installation tool. To break the connection later, you'll have to pull wire back out. The connectors also have test sockets to safely test voltage after installation.

Flip a clamp onto your wire instead of crimping to speed up installations and reuse your splice later. Choose these splices for setups that change often, such as prototypes and testing. They even have test sockets to safely test voltage after installation.

An economical alternative to our quick-connect clamp-on option, these splices are as quick to install but harder to adjust. Push wire into each end without the need for an installation tool. The splices have a test socket to safely test the voltage after installation.