Mount this light on a pole to illuminate pedestrian areas such as streets and walkways.

These lights automatically turn on when movement is detected and off when an area is unoccupied.

Heads adjust to any angle so you can direct light where needed.

These lights are UL listed for use in hazardous locations where flammable/combustible gases, vapors, and liquids may be present.

These lights produce a wide beam of uniform light to fill large, open areas with ceilings up to 18-ft. high.

Built for hot, hazardous areas such as steel mills and refineries, these lights work in temperatures up to 212° F. Rated NEC Classes I and II, they’re safe to use where there are ignitable concentrations of flammable or combustible gases, vapors, liquids, and dust.

Don’t waste energy lighting unoccupied spaces—these lights turn on when they detect movement.

Customize these lights to label doors or areas of a building.

Create ambient and accent lighting with these sleek, modern lights that shine above, below, and around themselves.

Also known as sconces, these lights are a stylish choice for ambient and accent lighting in hallways and entryways. They’re UL or ETL listed for wet locations, so you can install them outdoors—rain and humidity won’t be a problem.

Mount add-on heads in remote areas to extend emergency lighting.

Rated for use in damp locations, these lights withstand humidity and moisture.

Rated NEMA 4X, these lights are protected from corrosion and washdowns.

A flexible design allows these lights to be suspended above, wrapped around, or routed through areas on the job site.

Pop these lights on magnetic surfaces to brighten wet spaces. Rated NEMA 6 and ETL listed, you can splash, spray, or dunk them in water, and they’ll keep working.

Keep excess cords out of your way—the reel locks the cord at any length and retracts it when not in use.

Light up damp areas—these lights seal out moisture and humidity. They’ll even work in areas with frequent washdowns. Rated NEMA 4X, they withstand spraying liquid, resist corrosion, and keep out dust.

Power these lights with the same battery as your other cordless tools. They run on a Milwaukee M18 battery to light up work where there’s no outlet.

Because these lights are compatible with DeWalt rechargeable batteries, you can keep one type of cordless tool battery on hand. Their head pivots to aim light where it's needed in areas that don't have electrical power service.

Point light where it’s needed—even in wet areas. These lights are sealed against splashing and dripping water.

Splashes and drips are no problem for these lights. They don’t need an outlet, so you can bring them wherever you need them.

Flood hazardous areas with light—these lights are intrinsically safe, meaning they can’t cause an explosion or fire. Rated NEC Class I, II, III, and Zone 0, they’re safe to use in areas with ignitable concentrations of flammable or combustible gases, dust, and fibers.

Safe to use in areas with ignitable concentrations of flammable or combustible gases, vapors, liquids, and dust, these lights are rated NEC Class I, Class II, and Zone 1.

Bring light to remote areas with the DeWalt rechargeable battery that's already in your toolkit.

Brighten remote areas, even if they’re damp or rainy. These floodlights are IP rated to keep out humidity and dripping, splashing, and falling liquids.

Direct your signal with these lights; they flash in one direction.

These lights have lenses that snap in and out, so you can easily swap colors or change their position in the stack.

These lights have LED bulbs for years of maintenance-free operation and can be wired as either continuous or flashing.