Illuminate chemical plants, refineries, and other facilities where flammable and combustible gases may be present in the event of a leak or ventilation failure. These lights are rated for use in NEC Class 1, Division 2 hazardous locations.

The enclosure on these jelly jar lights contains explosions, sparks, and flashes. These lights are safe to use in NEC Class I, II, and III, Division 1 hazardous locations.

Safely light up chemical processing plants, mining operations, and other large areas where combustible gases and dust are present. These lights have an explosion-proof housing that contains sparks and flames, so they won’t react to nearby hazards.

Mount these lights in large, open areas where flammable and combustible gases may be present, such as during leaks or ventilation failures. These lights are rated for use in NEC Class 1, Division 2 hazardous locations.

IP or NEMA rated, these lights have a sealed lens to keep dust and moisture out for protection against washdowns. All meet ETL or UL standards for wet locations.

Illuminate harsh, wet areas, even outside in extreme weather—these lights are often used on ship building ports. Rated NEMA 4X and UL marine listed, they’re sealed against heavy rain and washdowns, and they won’t corrode from salt water or other liquids.

Illuminate areas that need frequent cleaning, such as food processing lines, with long rows of lights. Rated IP65, these lights have a sealed lens and liquid-tight end caps that protect them from low-pressure washdowns and dust.

Mount these lights flush with ceilings in wet locations—all are sealed to keep out humidity and dripping, splashing, and falling liquids. Unlike recessed can lights, which require a separate housing, these fit directly into a cutout in your ceiling and are held in place by springs.

Tough enough for offshore rigs and seafaring vessels—yet less than half the height of typical jelly jar lights. Built with a thick aluminum housing and a tough polycarbonate lens, these lights withstand hard impact without a guard.

With more surface area than round bay lights, these fixtures produce softer light with less glare. Use them to replace old fluorescent lights and illuminate large, open areas with high ceilings.

Rated for over a decade of use well above 100° F, these linear bay lights long outlast standard facility lights in high heat.

To keep contaminants from entering your clean room, these lights seal against drop ceilings with an airtight gasket.

Also known as wall packs, these lights mount to exterior walls and ceilings.