About Wire and Cable
More
High-Voltage Continuous-Flex Flat Cable
- Use For: Automation, Continuous Motion
- Continuous Flex
- Temperature Range: -85° to 325° F
- Insulation: Silicone Rubber
A thick outer layer of silicone rubber insulation protects this cable from high voltages while remaining ultra flexible. You'll often see this cable used in harsh environments with tight turns, from robotics and aerospace to oil rigging, because it won't break down from chemicals, oil, moisture, or UV light. It stands up to continuous motion without degrading data or signal transmission.
This cable meets UL 94 V-0 for flame retardance. If it is exposed to flames, it minimizes how much smoke and halogen it releases. It also meets clean room standards because it releases minimal particles into the air.
Bend radius is the point to which the cable will bend without being damaged. It is measured from the center of the bend to the edge of the cable. The smaller the measurement, the tighter the bend.
Per Ft. | |||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Wire Ga.  | No. of Wires | Cable AWG | Current | Wd. | Thick. | Bend Radius | Outer Insulation Color | Performance Properties | Environment | Environmental Rating | Specifications Met | Length, ft. | 1-99 | 100-Up | |
Stranded Wire | |||||||||||||||
12,000V DC/17,000V AC | |||||||||||||||
| 26 | 8 | 26/8 | 6 A @ 86° F | 0.46" | 0.09" | 0.9" | Clear | Low Smoke/Zero Halogen | Clean Room | Fed. Std. Class 1, ISO Class 3 | UL Recognized Component, CSA Certified, UL 94 V-0 | 00000000 | 00000 | 00000 | |
Servomotor Continuous-Flex Cable
- Use For: Automation, Continuous Motion, Interference Shielding, Motors
- Continuous Flex
- Temperature Range: -40° to 175° F
- Insulation:
Outer: Polyurethane Rubber
Inner: Polypropylene Plastic
Connect servocontrollers and servomotors in automated equipment and on assembly lines. This cable withstands continuous motion without degrading data or signal transmission. The polyurethane rubber insulation resists abrasion and oil. It’s flame rated VW-1 to meet requirements for preventing the spread of flames based on a timed test with vertically suspended material.
Cable with signal wires is also known as feedback cable. It sends and receives signals between a servomotor and a PLC.
Shielded cable has a layer of braid that blocks signal interference from nearby equipment and devices.
Bend radius is the point to which the cable will bend without being damaged. It is measured from the center of the bend to the edge of the cable. The smaller the measurement, the tighter the bend.
| No. of Wires | Wire Ga. | Cable AWG | Current | OD | Bend Radius | Outer Insulation Color | Inner Insulation Color | Specifications Met | 5 ft. | 10 ft. | 20 ft. | 30 ft. | 50 ft. | |
Shielded—30V AC/45V DC | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 8 | 26 | 26/8 | 0.7 A @ 86° F | 0.25" | 2.17" | Green | Black, Blue, Brown, Green, Orange, Purple, Red, Yellow | UL Recognized Component, UL 2556 VW-1 | 0000000 | |||||
Ethernet Cable
- Use For:
Unshielded: Data; Category 3 can also be used for Telephones
Shielded, Double Shielded: Data, Interference Shielding - Flexible
- Insulation:
Outer: PVC Plastic
Inner: See table
Send data between computers, printers, servers, and switches. Ethernet category standards describe the cable’s performance capabilities. Higher category numbers mean faster speeds, superior data transfer, and better signal strength. Category cables are backward compatible, so you can mix and match, but your speed will only be as fast as the lowest-rated cable.
Shielded cable has a layer of foil that blocks signal interference from nearby equipment, such as variable frequency drives or small motors. It has an uninsulated ground wire that is not counted in the number of wires.
Double-shielded cable has a layer of braid and foil shielding for the best protection against signal interference. Use it in areas with high signal distortion, such as near transformers, generators, and heavy duty motors.
CM and CMR cable prevent the spread of flames down the length of the cable. CMR is more flame resistant than CM cable.
Inner Insulation | Per Ft. | |||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Ethernet Cable Category | Transmission Frequency | Wire Ga. | No. of Wires | Cable AWG | Max. Temp., °F | OD | Industry Designation | Material | Color | Outer Insulation Color | Length, ft. | 1-499 | 500-Up | |
Shielded Stranded Wire with Uninsulated Ground Wire | ||||||||||||||
| 5E | 100 MHz | 26 | 8 | 26/8 | 140° | 0.22" | CM | Polyethylene Plastic | Blue Blue/White Brown Brown/White Green Green/White Orange Orange/White | White | 0000000 | 00000 | 00000 | |
Double-Shielded Stranded Wire | ||||||||||||||
| 6A | 500 MHz | 26 | 8 | 26/8 | 175° | 0.27" | __ | Polyethylene Plastic | Blue Blue/White Brown Brown/White Green Green/White Orange Orange/White | Yellow | 000000 | 0000 | 0000 | |
Continuous-Flex Ethernet Cable
- Use For: Automation, Continuous Motion, Data, Interference Shielding
- Continuous Flex
- Outer Insulation: TPE Rubber, except Category 6A is Polyurethane Plastic
Inner Insulation: TPE Rubber, except Category 6A is Polyolefin Plastic
Often used in automated applications that require continuous motion such as robotics, this cable sends data between computers, servers, and switches without degrading data transmission. This Ethernet cable is backward compatible so it works in networks that meet the same or a lower category. It is double shielded, which means it has a layer of braid and foil shielding for better protection against signal interference than braid alone. Use it in environments with high signal distortion, such as near transformers, generators, and heavy duty motors. Bend radius is the point to which the cable will bend without being damaged. It is measured from the center of the bend to the edge of the cable. The smaller the measurement, the tighter the bend.
Flame rated cable meets requirements for preventing the spread of flames based on a timed test. FT1 cable is suspended vertically during testing. FT2 cable is suspended horizontally during testing.
For technical drawings and 3-D models, click on a part number.
Per Ft. | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Ethernet Cable Category | Transmission Frequency | Wire Ga. | No. of Wires | Cable AWG | Temp. Range, °F | OD | Bend Radius | Outer Insulation Color | Inner Insulation Color | Specifications Met | Length, ft. | 1-99 | 100-Up | |
Double-Shielded Stranded Wire | ||||||||||||||
| 5E | 100 MHz | 26 | 8 | 26/8 | -30° to 155° | 0.33" | 3.3" | Purple | Blue, Blue/White, Brown, Brown/White, Green, Green/White, Orange, Orange/White | UL Recognized Component, C-UL Recognized Component, UL 2556 FT1 | 0000000 | 00000 | 00000 | |
| 6 | 250 MHz | 26 | 8 | 26/8 | -30° to 155° | 0.33" | 3.3" | Purple | Blue, Blue/White, Brown, Brown/White, Green, Green/White, Orange, Orange/White | UL Recognized Component, C-UL Recognized Component, UL 2556 FT1 | 0000000 | 00000 | 00000 | |
| 6A | 500 MHz | 26 | 8 | 26/8 | -40° to 155° | 0.28" | 4.2" | Green | Blue, Blue/White, Brown, Brown/White, Green, Green/White, Orange, Orange/White | UL Recognized Component, C-UL Recognized Component, CSA Certified, UL 2556 FT2 | 000000 | 0000 | 0000 | |