We will reply to your message within an hour.
More
These steel screws are zinc plated to resist corrosion in wet environments.
18-8 stainless steel screws have good chemical resistance.
Stronger and more wear resistant than 18-8 and 316 stainless steel, these screws are mildly chemical resistant.
More corrosion resistant than 18-8 stainless steel screws, these have excellent resistance to chemicals and salt water.
Made from 18-8 stainless steel, these screws are chemical resistant.
One-third the weight of steel, aluminum screws resist corrosion in wet environments.
These steel screws are available with corrosion-resistant finishes.
Brass screws are corrosion resistant in wet environments and electrically conductive.
A Torx drive has more points of contact than Phillips, slotted, and square drives, allowing you to apply extra force with less slippage or damage to the recess.
A thick, decorative head provides a finished appearance.
A free-rotating, permanently attached washer distributes holding pressure over a wider area than a flange and remains stationary to prevent scratching the material surface as you tighten the screw.
A flange under the head distributes holding pressure and reduces the risk of crushing thin metal.
These square-drive screws have a flange under the head that distributes holding pressure and reduce the risk of crushing thin metal.
A tamper-resistant Torx driver is required for installation and removal. Also known as pin-in-Torx, these screws allow you to apply extra force with less slippage or damage to the recess.
The S-shaped drive can be installed with a standard slotted driver, but requires a special tool for removal.
These screws require a Tri-Wing® driver for installation and removal.
Install and remove these screws with a tamper-resistant spanner driver.
Also known as pin-in-hex, install and remove these screws with a tamper-resistant hex driver.
These square-drive screws are beveled under the head for use in countersunk holes.
These steel screws have a black-oxide finish to resist corrosion in dry environments.
Made from 410 stainless steel, these screws are strong, wear resistant, and mildly chemical resistant.
Serrations under the head act as a brake to prevent over tightening and damaging threads.
Able to penetrate overlapping sheets, these screws have a secure hold in wood.
For a finished appearance that reduces the chance of snags on other material, these screws fit snugly in countersunk holes and have a domed head.
Cutting wings under the head allow plastic to expand and contract without cracking. A washer made from aluminum and rubber bonded to steel adds a watertight seal.
A point centers the screw in a starter hole and widely spaced threads reduce the risk of cracking plastic.
These blue and silver ultra-corrosion-resistant coated steel screws stand up to wet environments.
These 410 stainless steel screws are more corrosion resistant than ultra-corrosion-resistant coated steel screws.
Fasten sheet metal up to 0.200" thick.