Made from 316 stainless steel, these propellers have excellent corrosion resistance.

Also known as hydrofoil propellers, these produce 40% more flow with less torque and energy than standard propellers.

Blades collapse to fit through 2" diameter and smaller openings, such as 55-gallon drums with a NPT opening size of 2.

For faster attachment than propellers with set screws, these propellers have threaded hubs that install on threaded shafts.

Propeller blades collapse to fit in drum openings with a NPT size of 2. They're PVC coated for chemical resistance.

These general purpose gas springs assist in opening lids, covers, windows, conveyors, and seats—similar to a hatchback opening on a car.

Mechanical operation means these springs have no seals to fail or gas to leak.

With no gas to leak out and a corrosion-resistant 316 stainless steel construction, these mechanical springs are built for long-term, maintenance-free use in wet environments.

Made from stainless steel for excellent corrosion resistance in damp environments.

Ensure you have the correct force for your application. These gas springs have a bleed valve so you can release gas to permanently reduce the force to meet your requirements.

Automatically locking when fully extended and made of 316 stainless steel to resist corrosion, these gas springs protect material and equipment underneath heavy loads in damp environments.

Made from stainless steel for excellent corrosion resistance in damp environments.

Pair one of these gas springs with a release control to stop and release the gas spring anywhere along the stroke with the push of a button or lever.

Attach eyelet end fittings to these brackets to mount gas springs.

Made from stainless steel for excellent corrosion resistance in damp environments.

Keep environments free of contaminants—with plastic bushings, there's no metal-to-metal contact that can release particles as these supports open and close. Manually control these free-moving lid supports through their full range of motion. Raise the lid until the hold-open mechanism on the support is engaged; slightly lift it again to release the hold and close the lid.

Also known as hatch springs, these supports are commonly used on hatches and other top-opening lids. Raise the lid to extend the spring, which props the lid open—an internal cable keeps the spring from overextending. Press the center of the spring to release the hold and close the lid.

Commonly used on hood and trunk lids, these simple, three-piece rods telescope from 18 1/2" to 46 3/4" to prop lids open at a variety of angles.

No separate hinges are required, these supports act as a hinge and lid support all in one. Springs provide lifting assistance to raise and hold lids open—slightly lift the lid to get it started and the support will do the rest. Manually shut the lids and the supports will hold them in the closed position.

Gradually slow your lid's motion to prevent it from slamming open. To open lids, lower them and the support will slowly and softly do the rest. Manually shut the lids and the supports will hold them in the closed position.

Replace worn and damaged fan blades. Use the included set screw or shaft collar to fasten a blade to your fan's shaft.