These switches use DC input voltage and produce PNP or NPN signal output. They're often used with programmable logic controllers (PLCs).

The flexible cable on these switches withstands applications that require frequent motion, such as robotics.

Easily mount these flat switches to a base or rail.

The short body on these switches makes them suitable for tight spaces.

These inductive proximity switches sense metallic objects each time they pass through the slot, even when they’re obscured by water, oil, dirt, or a surface finish. Use them to measure the speed of rotating equipment and to count or detect moving objects, such as sheet metal being fed into a stamping process.

Sense objects as they pass through the switch’s ring via tubing or a funnel. These switches are often used to monitor blockages, detect breaks in spooling wire, or count small metallic parts, such as screws, during the stamping process.

Mount these intrinsically safe switches to flat surfaces in volatile areas. Their low-current, low-voltage NAMUR signal means they won’t ignite or create sparks while in use. ATEX and IECEx certified, they meet international standards to protect against explosion where combustible dust and flammable gases are present.

These intrinsically safe switches detect objects as they’re routed through the ring. They produce a low-current, low-voltage NAMUR signal, so they won’t ignite or create sparks. Switches are ATEX certified to protect against explosion.

Most often found in older devices, these switches require AC input voltage.

Rotate the face on these switches five different directions for easy installation and positioning—they work with both AC and DC inputs.

Detect the presence or absence of an object moving at high speeds with a light beam. These switches have a longer sensing distance than proximity and ultrasonic switches.

For optimal performance in tight spaces, these switches have a smaller beam and can detect smaller objects than standard photoelectric switches.

These switches have a receiver built into the housing, eliminating the need to align components and measure sensing distance during installation.

Set these switches to delay activation by up to five seconds after detecting an object.

Transmit a beam of light up to 225 ft. from the transmitter to the receiver.

The highly flexible fiber-optic cable and small sensing end help you position these switches in hard to reach areas.

Safely detect the presence or absence of an object moving at high speeds with a light beam. These switches produce a low-current, low-voltage NAMUR signal, so they won’t create sparks or ignite. ATEX and IECEx certified, they protect against explosion in environments containing flammable gases and combustible dust.

Often used with programmable logic controllers (PLCs), these switches use DC input voltage and produce PNP or NPN signal output.

Rated NEMA 4X, 6P, IP68 and IP69K, these switches resist corrosion and high-pressure, high-temperature washdowns, and can withstand temporary submersion.

Switches accept both AC and DC input voltage.

Support flow and temperature control in your system with these intrinsically safe switches, which sense when a valve is open or closed in volatile areas. They are ATEX and IECEx certified to protect against explosion.

This switch mounts to the outside of your tank and detects chemical level through plastic tank walls by measuring the capacitance between the switch and tank contents; it cannot be used with metal tanks.

Measure the level of conductive liquids without drilling a hole in your tank—these switches mount to the outside of the tank and track the capacitance between them and the tank’s contents.

Position proximity, photoelectric, and light beam sensors and switches.

Clamp around sensors and switches for a secure hold.

Designed to fit most limit switches, these brackets allow switch-position adjustments after they are fastened to equipment.