In addition to providing excellent sealing performance at low pressure, these seals withstand a wider range of temperatures and chemicals than U-cup seals. They’re also known as spring-energized seals.

A square O-ring prevents these piston seals from rocking in the groove.

PTFE gives these seals a slippery surface that facilitates rod speeds over seven times faster than our other buffering seals. They're rated for pressure up to 5,000 psi.

Made from MDS-filled PTFE for a slippery surface, these wipers allow rods to move three times faster than other rod wipers.

Made of FDA-listed material for use with food and beverage, these PTFE seals are lubricated with mineral oil. Use them in pumps.

Also known as 100% GFO, these expanded PTFE seals contain graphite powder, which dissipates heat away from the shaft and allows pumps to run cool at high speeds.

These lubricated PTFE fiber seals stand up to most chemicals. Use them in pumps and valves.

Made of Gore PTFE, these premium seals are soft, so they conform to fill irregularities caused by wear in valve stems.

Made of PTFE-impregnated synthetic fiber, these seals are for use in pumps.

Made of Teflon® PTFE, these gaskets are chemically inert (except to molten alkali metal and elemental fluorine).

If a piece wears off, fragments as small as 1 mm can be picked up by a metal-detection system to prevent contamination of your process line.

Made from a blend of PTFE and 316 stainless steel, these gaskets hold up to the harsh chemicals, high pressures, and high temperatures used in sanitary processes.

These pure PTFE gaskets have a slippery surface that prevents sticking.

For use with cast iron pipe flanges, these specially formulated gaskets are also known as Gore UPG ring gaskets.

These soft expanded PTFE gaskets are made of FDA-listed material for use with food and beverage.

Reinforced with fiberglass filler for strength, these PTFE gaskets won't thin out when compressed.

Made of pure PTFE, these gaskets have a slippery surface that prevents sticking.

Use these gaskets, also known as Gore UPG, with cast iron flanges.

Because this expanded PTFE tape is thicker than other gasket tape, it fills the irregularities on rough-surfaces flanges when compressed for a tight seal.

This material is made of expanded PTFE. It is more compressible than pure PTFE to ensure a tight seal.

Rigid and hard with a slippery surface, these PTFE O-rings resist harsh chemicals, such as acetone, fluorinated solvents, methanol, and boric acid.

These temperature- and chemical-resistant O-rings prevent leaks in tube fittings that have a straight-thread connection, also known as O-ring boss fittings.

These 325-piece assortments mean you’ll always have a backup ring on hand.