Push the lever to lock the handle and prevent accidental opening.

Mount the clamp on a lid and the latch plate on the side of a container.

Smaller than standard push/pull toggle clamps, these are often used for electronics and small fixturing applications.

A highly durable construction with hardened steel pivot pins and bushings provides a long service life.

Secure your workpiece from the side by fully extending the plunger, and push a lever to lock the handle in place.

Hold workpieces of different thicknesses without adjustment.

Panel mount through a hole with the included nut, or drill and tap a hole to flush mount. A pushing or pulling motion holds workpieces from the side.

Secure these clamps to a rail or bar.

Drill a hole to mount these clamps through a surface and secure the mounting flange with screws. The plunger can be locked at any position along its travel.

These latches reach around outside corners to draw two surfaces together—use them to secure cases, toolboxes, and other containers.

A safety catch prevents accidental opening.

A plastic-coated handle and hook prevents the release of particles from metal-to-metal contact, which makes these latches good for clean room applications.

To prevent accidental opening, these latches have a safety catch.

Mount these latches on a corner to draw perpendicular surfaces together.

The latch arm is coated with vinyl so it won't scratch surfaces.

No need for a strike plate, these latches hook into a lip or notch.

Adjust the latching distance for a tight fit over gasketing and to compensate for misalignment.

To prevent accidental opening, these latches have a safety catch.

Use these L-handle latches to draw lightweight surfaces together.

Lift and turn the handle 180° to open and close these latches.

To secure overlapping components, pull the slide over the stud until they snap together. These latches resist shock and vibration.

Add a padlock to secure these latches, which reach around corners to pull two surfaces together.

Mount these latches on a corner to draw perpendicular surfaces together. They have a safety catch to prevent accidental opening.

An integrated slide bolt extends into the strike plate to resist pull and vibration from side-to-side, front-to-back, and up-and-down forces.

Lift and turn the handle 180° to open and close these latches. Add a padlock to secure.