For applications that require a large gripping area, these handles have a center-to-center distance of 12" or more. Thread screws through holes from the back of your surface into the handles to open and close a variety of doors and drawers on furniture, machines, and equipment.

Open and close a variety of doors and drawers on machines and equipment next to food processing lines while reducing the risk of contaminating the food. Thread screws through holes from the back of your surface into the handles to install them.

Thread screws through holes from the back of your surface into the handles to open and close a variety of doors and drawers, including those on furniture, machines, and equipment. The grip is offset from the mounting surface so there's room to fully grasp the handle.

These handles provide a stronger connection than those attached with screws or nuts. They fit into a cutout, so they are flush with the mounting surface. Use them to open and close a variety of doors and drawers, including those on furniture, machines, and equipment.

Thread screws through holes from the back of your surface into the handle to open and close a variety of doors and drawers, including those on furniture, machines, and equipment. These handles fit into a cutout, so they’re flush with the mounting surface.

Thread a screw through a hole from the back of your surface into the knobs to open and close a variety of doors and drawers, including those on furniture, machines, and equipment.

Mount these knobs in a cutout to keep them out of the way when not in use. Push the grip to extend, and push it again to recess. Use these knobs to open and close a variety of doors and drawers, including those on furniture, machines, and equipment.

Mount these pulls to the edge of drawers, panels, and doors. When closed, only the fingertip grip is visible.

These handles are often used as grips on hand wheels or cranks to operate machinery around food processing lines without the risk of contaminating the food. Install them on a threaded stud.

Attach a ball knob to one of these shafts to create custom handles for operating machinery.

These rugged steel handles provide lasting durability for applications involving frequent positioning, tightening, and holding adjustments. Lift the handle to rotate freely; then release the handle to engage and tighten. These handles are also known as clamping handles.

Prevent unintentional changes to equipment settings—when not in use, these handles are disengaged and turn freely. To change the position, push down on the handle and turn. When you release the handle, it disengages once again. These handles are also known as clamping handles.

Use these standard cam handles for most clamping applications. Push down on the handle and the head applies pressure to quickly draw two parts together for fast adjustments.

Use these handles to keep holes aligned or lift several sheets of thin material. They have a plug that expands to grip the edges inside holes. They are not suitable for permanent installation—use only for temporary mounting.

Position, tighten, and hold fixtures, equipment, and machinery near food processing lines without the risk of contaminating the food. Install these knobs on a threaded stud.

Quickly identify equipment controls and components by their color. Use these knobs to control devices with round shafts and view settings at a glance with a pointer.