The ring pivots 90° or 180° to secure loads in various directions.

Accommodate ties in any direction with these rings that swivel all the way around.

Adhesive on the back holds these rings in place.

The ring pivots 180° to secure loads in various directions. Also known as lashing rings.

Large holes in the base allow adhesive to flow through.

Use these guides to position a rope.

The ring pivots to secure loads in various directions.

Hang, pull, and secure loads. These rings are good for general non-lifting applications.

Limit rope and chain movement with the narrow end of these links and attach multiple connectors to the wide end.

The narrow end restricts the movement of rope and chain, and the wide end allows room to attach multiple connectors.

Flat sides allow webbing and strapping to lay flat, so they won't slide and bunch.

Best for attaching different widths of webbing and strapping, the flat sides ensure they lay flat and won't bunch or slide.

Also known as lap links or repair links.

Strike the prongs with a ball peen hammer and they expand to hold the connecting link together.

Also known as master and sling links, a large inner diameter provides room to attach multiple connectors or legs on a sling.

Providing better load distribution and alignment than single oblong links, these reduce wear in three and four leg slings.

Once secured with the included locking pin, these links must be cut off to be removed.

Hammer the pin through the center to assemble these links. They’re also known as hammer locks and sling links.

Remove the shackle after lifting while keeping the base installed for future use.

Designed for angular lifting, hoist rings resist stresses that would bend or break an eyebolt. They have a lifting ring that pivots 180° front to back to compensate for roll and sway when lifting heavy or unbalanced loads.

Fasten these handles directly to the front of your surface. They fit into a cutout, so they are flush with the mounting surface. Their grip drops out of the way when you let go. Use them to open and close a variety of doors and drawers on chests, crates, furniture, machines, and equipment.

Anchor these ringbolts where you need them, then remove the ring when not in use. Once installed, the mounting bolt stays in place. Insert the ring by threading into the mounting bolt; remove by unthreading it.