Puller Thread Adapters | McMaster-Carr

	Thread Size Thread Size

	Gender Gender

Female

Male

	DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense Acquisition Regulations Supplement)

DFARS Specialty Metals
COTS-Exempt

	OD OD

	Diameter Diameter

	Thickness Thickness

25 Products

Threaded Adapters for Pullers

Use adapters on the ends of forcing screws and face-grip puller legs when pulling shafts, bearing caps, and pinions.

Thread Size	Gender		Each
1/4"-20 × 5/8"-18	Male × Female	000000	000000
5/16"-18 × 5/8"-18	Male × Female	000000	00000
3/8"-16 × 5/8"-18	Male × Female	000000	00000
3/8"-24 × 5/8"-18	Male × Female	000000	00000
7/16"-14 × 5/8"-18	Male × Female	000000	00000
7/16"-20 × 5/8"-18	Male × Female	000000	00000
1/2"-13 × 5/8"-18	Male × Female	000000	00000
1/2"-20 × 5/8"-18	Male × Female	000000	00000
5/8"-18 × 1"-14	Male × Female	000000	00000

Shaft Protectors for Pullers

Use a shaft protector on the tip of your forcing screw to prevent damage from pressure applied by the puller and forcing screw.

OD	Thick.		Each
5/8"	5/8"	0000000	000000
3/4"	3/4"	0000000	00000
1"	3/4"	0000000	00000
1 1/4"	3/4"	0000000	00000
1 1/2"	3/4"	0000000	00000

Step-Plate Adapters for Pullers

Pull bearings, gears, and other parts from hollow shafts and housings. Place one of these adapters in the end of your hollow shaft to provide a surface for the forcing screw to push against.

For technical drawings and 3-D models, click on a part number.

Dia.	(A)		Each
1"	3/4"	00000000	000000
1 1/8"	7/8"	00000000	00000
1 1/4"	1"	00000000	00000
1 3/8"	1 1/8"	00000000	00000
1 5/8"	1 1/4"	00000000	00000
1 3/4"	1 3/8"	00000000	00000
1 7/8"	1 1/2"	00000000	00000
2"	1 5/8"	00000000	00000
2 1/8"	1 3/4"	00000000	00000
2 3/8"	1 7/8"	00000000	00000
2 1/2"	2"	00000000	00000