The built-in contact block in these switches extends behind the panel half the depth of most other 22 mm switches, saving valuable space.

A single-piece construction prevents the contact block from separating from the actuator in high-vibration applications.

The face of these switches mounts flush against a panel, so they're easy to clean and hard to damage.

Immediately cut power with a single push.

Save space on a panel by using one switch to perform multiple switching functions.

Operate low-voltage devices that require less than 48 volts, such as doorbells and buzzers.

Immediately cut power with a single push.

Also known as tactile switches, these are small enough to fit inside a computer keyboard.

Operate low-voltage devices that require less than 48 volts, such as doorbells and buzzers.

Install in 12 mm dia. cutouts.

More lightweight than steel or stainless steel, these aluminum enclosed switches are rated NEMA 4X for protection from corrosion and washdowns.

Rated NEMA 3S, NEMA 4X, NEMA 13, and IP66, these plastic switches resist corrosion better than aluminum switches and withstand washdowns and oil/coolant spraying.

A red light flashes when the actuator is pushed, making it easy to see from a distance. They're rated IP65 for protection from washdowns.

Often used to trigger alarms, these switches have a recessed button to prevent accidental activation. Mount under desks or in other discrete locations to avoid drawing attention.

Mount these switches in an outlet box. Also known as palm-button switches, they have a large button that makes them easy to use even while wearing gloves.

Choose an actuator and contact block to make your own 22 mm plastic switch.

Choose an actuator and contact block to make your own 22 mm metal switch.

Use these hand-held switches with mobile machinery.

Control cranes and other mobile machinery in dirty, outdoor, and wet environments without damaging your switch.

Operate equipment from up to 330 feet away—these switches include a transmitter and a receiver that connects to equipment.

An infrared light beam senses the lightest finger contact to switch a circuit on or off.

Use these switches in place of standard wall switches to automatically turn electrical equipment on or off after a set interval of time.