Smaller than standard push/pull toggle clamps, these are often used for electronics and small fixturing applications.

Pull the handle backward to push the plunger forward. These clamps secure when the plunger is fully extended to hold your workpiece from the side.

Secure your workpiece from the side by fully extending the plunger, and push a lever to lock the handle in place.

Moving parts are sealed to prevent dirt and dust from clogging the clamp.

Panel mount through a hole with the included nut, or drill and tap a hole to flush mount. A pushing or pulling motion holds workpieces from the side.

Secure these clamps to a rail or bar.

Drill a hole to mount these clamps through a surface and secure the mounting flange with screws. The plunger can be locked at any position along its travel.

Also known as toe clamps, these grip the side of a workpiece to leave the top free for machining.

The spring-loaded tips on these clamps swivel in all directions to make maximum contact with angled and uneven workpieces.

When loosened, you can spin the body of this clamp around its mounting point for better access to the workpiece.

Machine these clamps to match the contours of your workpiece and turn the screw to grip.

Machine these fixture clamps to match the contours of your workpieces for a stronger grip. Place the clamp between the two workpieces in a fixture and tighten the screw to extend the sides of the clamp, creating a secure hold against both workpieces.

Install these clamps into a slot in your fixture to grip at the bottom of a workpiece edge, giving the cutting tool maximum access.

Secure a workpiece from the inside, leaving the outside clear for machining.

Apply pressure to the side of a workpiece as well as the top and bottom.

Attach to your bar clamp to hold material on three sides.