These surface fillers can be used on vertical surfaces without sagging. They repair cracked, worn, and damaged surfaces.

Press these putty surface fillers in place to fill in holes, cracks, and dents. When exposed to sunlight or a UV lamp, they begin to harden immediately.

Use these two-part fillers to rebuild cracked or worn plastic surfaces.

Epoxies are the strongest and most weather- and chemical-resistant structural adhesives. They work especially well on metals.

These machinable epoxies are mixed with steel, but won’t rust, so they can be used to repair cracks and threaded holes.

To allow time to adjust and position parts, these epoxies remain workable for at least 90 minutes.

Also known as thumb-grade caulk, this forms a non-hardening, moisture-resistant seal that remains pliable.

Made from silicone, these sealants are RTV (room-temperature vulcanizing).

These sealants include a material certificate with traceable lot number, test report, and product shelf life.

Tested to meet ASTM E595, a standard used by NASA, these sealants fill joints and seams while releasing almost no volatile emissions that could damage sensitive electronics, even in a vacuum.

This sealant includes a material certificate with traceable lot number, test report, and product shelf life.

A combination of hardness and surface tension makes these sealants resistant to punctures, cuts, and abrasion.

Apply these sealants in cold temperatures, on wet surfaces, and even through running water.

Thinner than non-sagging sealants, these flow easily into cracks and have a smooth finish.

Thinner than non-sag sealants, these flow easily into cracks and have a smooth finish.

These non-sagging sealants will not drip while hardening on vertical and overhead surfaces.