Replace worn shafts in two-piece support-rail shaft systems, or mate with a support rail to create your own. The tapped mounting holes match those on our Support Rails.

Mount these externally threaded shafts into tapped holes rather than using a shaft support, or attach a hex nut, shaft collar, or other threaded accessory.

Clip retaining rings into the grooves to separate and position collars, supports, and housings.

Use these rails with any track rollers that have a 90° V-groove.

Half the height and the same width as regular strut channel, this low-profile strut channel fits into tight spots and is compatible with many of the same brackets.

A spring plus serrated grooves that grip the lip of the channel provide a more secure hold than standard strut channel nuts.

Quickly attach these nuts by twisting them closed at any point along a threaded rod.

Use with hex nuts to connect threaded rod.

Create a four-sided raceway for cable, or give a more finished look to strut channel structures.

A tab on the end of these shelf brackets fits inside the strut channel for extra stability.

Slip these posts and rails together for a complete railing—no fittings required.

No need to shut these gates behind you—springs automatically do it for you.

Built to withstand corrosive marine environments, track is anodized aluminum and hangers are 316 stainless steel.

Install these drawer slides in small-parts cabinets.

The size of a finger, these tiny slides open in both directions. All have ball bearings for smooth operation.

When you don't have enough clearance for side-mount or under-the-counter slides, mount these to the base of your drawer.

Use these guides to help control your door's motion and keep the bottom of the door from swinging.

Use brackets and connectors to create vertical and horizontal support arms.

The pivoting joint on these rods makes angle-mounting easy.

Graduated in 1/8" increments, these rods make it easy to align multiple brackets during installation.

Also known as cross blocks, connectors join rods at different angles.

Brackets are sized to mount sensors and reflectors to a conveyor frame.

Designed to hang over your enclosure door, these shields protect latches, handles, and other exterior hardware from dripping water and falling dust.