McMaster-Carr logo
    Filter by
    System of Measurement
    For Dowel Pin Diameter
    Flute Type
    Shank Type
    DFARS Specialty Metals
    Export Control Classification Number (ECCN)
    Industrial Info Snippet
    Reamer Operation
    Container Type
    Number of Pieces
    Forward
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Print
    How can we improve?
    Comments
    E-mail address (if you would like a response)
    1 Product

    Reamer Sets for Dowel-Pin Holes

    Finish holes to match standard fractional dowel pin sizes. These sets include two reamers for each size within the range listed. One reamer is slightly below the size while the other is slightly above the size, so you can choose how snug your dowel pin will fit in the hole.
    Round Shank
    Image of Product. Front orientation. Reamers. Reamer Sets for Dowel-Pin Holes, Round Shank.
    These reamers fit in the chuck of drill presses, turret lathes, and other machine and power tools, making them the most common shank type.
    Straight Flute—The most common flute style, these reamers are suitable for a wide range of applications, but not recommended for holes with a keyway or other breaks in the surface.
    Cobalt Steel—With better heat and wear resistance than high-speed steel, these reamers run up to 25% faster, last longer, and perform better on hard materials, such as cast iron, hardened steel, titanium, and stainless steel.
    Sizes Included
    No. of
    Pieces
    Material
    Container
    Type
    For Use On
    Each
    Straight Flute
     
    Inch
    1/8"-1/2" (Increments of 1/16", 2 of each)14Cobalt SteelMetal CaseAluminum, Brass, Bronze, Iron, Nickel, Plastic, Stainless Steel, Steel, Titanium, Tool Steel, Hardened Steel00000000000000
    Cobalt Steel Reamers for Dowel-Pin Holes, 14 Pieces
    EachIn stock
     
    back to top