McMaster-Carr logo
    Filter by
    System of Measurement
    Reamer Diameter
    Container Type
    Shank Type
    Flute Type
    Number of Pieces
    Reamer Operation
    Material
    Overall Length
    Flute Length
    Number of Flutes
    Reamer Type
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    4 Products

    Reamers
    3D CAD models available

    Finish holes to precise inch, metric, wire gauge, or letter sizes with these reamers.
    Round Shank
    Image of Product. Front orientation. Contains Annotated. Reamers. Reamers, Round Shank, Straight Flute.

    Straight Flute

    These reamers fit in the chuck of drill presses, turret lathes, and other machine and power tools, making them the most common shank type.
    Straight Flute—The most common flute style, these reamers are suitable for a wide range of applications, but not recommended for holes with a keyway or other breaks in the surface.
    High-Speed Steel—Durable and wear resistant, these are good for general purpose reaming in most materials.
    Cobalt Steel—With better heat and wear resistance than high-speed steel, these reamers run up to 25% faster, last longer, and perform better on hard materials, such as cast iron, hardened steel, titanium, and stainless steel.
    Carbide—For the highest level of accuracy when cutting hard materials, these are our hardest, strongest, and most wear-resistant reamers. They're used on materials such as iron, hardened steel, steel alloys, and plastic. Their hardness means they are brittle, so a highly rigid setup, such as a CNC machine, is necessary to prevent the reamer from breaking.
    Length
    Reamer
    Diameter
    Material
    Flute
    Overall
    Number
    of Flutes
    Cutting Diameter
    Tolerance
    For Use On
    Each
    Straight Flute
     
    Metric
    7.5000 mmHigh-Speed Steel38.1 mm152.4 mm60 mm to 0.005 mmAluminum, Brass, Bronze, Iron, Plastic, Stainless Steel, Steel0000000000000
    7.5000 mmCobalt Steel38.1 mm152.4 mm60 mm to 0.005 mmAluminum, Brass, Bronze, Iron, Plastic, Stainless Steel, Steel, Tool Steel, Hardened Steel000000000000
    7.5000 mmCarbide28.6 mm82.5 mm60 mm to 0.0003 mmAluminum, Brass, Bronze, Fiberglass, Iron, Nickel, Plastic, Stainless Steel, Steel, Titanium, Tool Steel, Hardened Steel00000000000000
     

    Reamer Sets
    3D CAD models available

    Keep a variety of reamer sizes on hand for finishing holes.
    Round Shank
    Image of Product. Front orientation. Reamers. Reamer Sets, Round Shank.
    These reamers fit in the chuck of drill presses, turret lathes, and other machine and power tools, making them the most common shank type.
    Straight Flute—The most common flute style, these reamers are suitable for a wide range of applications, but not recommended for holes with a keyway or other breaks in the surface.
    High-Speed Steel—Durable and wear resistant, these are good for general purpose reaming in most materials.
    Sizes Included
    Number
    of Pieces
    Material
    Container
    Type
    For Use On
    Each
    Straight Flute
     
    Metric
    1-13 mm (Increments of 0.5 mm)25High-Speed SteelMetal CaseAluminum, Brass, Bronze, Iron, Plastic, Stainless Steel, Steel00000000000000
     
    back to top