Choose a Category
    Clear All
    Material
    Material
    Brass
    Stainless Steel
    Thread Type
    Thread Type
    Metric
    System of Measurement
    System of Measurement
    Metric
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Thread Size
    Thread Size
    Show
    Threaded Insert Type
    Threaded Insert Type
    Heat Set
    Installed Length
    Installed Length
    default
    Less than 5 mm
    Thread Insert Style
    Thread Insert Style
    Standard
    For Minimum Material Thickness
    For Minimum
    Material Thickness
    Less than 5 mm
    For Use In
    For Use In
    Plastic
    For Maximum Hole Diameter
    For Maximum Hole Diameter
    Less than 0.25"
    Less than 5 mm
    Drill Bit Size
    Drill Bit Size
    3 mm
    No. 32
    No. 44
    Thread Spacing
    Thread Spacing
    click to learn more about
    Thread Pitch
    Thread Pitch
    default
    0.35 mm
    End Type
    End Type
    Open
    Tensile Strength
    Tensile Strength
    50,000 psi
    80,000 psi
    Not Rated
    Thread Direction
    Thread Direction
    Thread Fit
    Thread Fit
    Class 6H
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)

    4 Products

    Tapered Heat-Set Inserts for Plastic

    Metric

    Heat-Set Inserts for Plastic

    Metric—Standard