Using a low-current signal, these relays are often used to control small motors and heaters.

The circular pin terminals plug into relay sockets for easy installation.

Solder these relays directly to printed circuit boards using their solder pin terminals.

With no moving parts, these solid state relays last longer, switch faster, and are quieter than mechanical relays. They interface between your controller and components to isolate input and output circuits, which protects components from voltage spikes, amplifies the relay’s signal, and reduces interference for reliable transmission.

These relays are rated for motors with 1-3 horsepower or 15-90 amps—use them with industrial automation systems, security and emergency lighting, and small motors. Also known as power relays.

Sealed for safety, these relays are a good choice for hazardous locations where combustible or corrosive gases may be present.

Operate equipment that cycles on and off from your control cabinet.

Control and diagnose issues with safety-critical circuits.

These relays switch through a series of different circuit configurations every time they receive an input voltage. Also known as step relays.

Control multiple timing functions from your electrical cabinet—these timer relays mount to 35 mm DIN rail (also known as DIN 3 rail), which is the most commonly used size.

Attach these relays to a flat surface using the mounting hole. They have no moving parts, so compared to mechanical switches, they require less maintenance, last longer, and are quieter.

Considered solid state because they don’t have any moving parts, these timer relays last longer, switch faster, and are quieter than mechanical relays. They interface between your controller and components to isolate input and output circuits, preventing damage to your components from voltage spikes, amplifying the relay's signal, and reducing signal interference. They have multiple timing functions, so you don’t need to swap out your relay if you want to change their function.

For fast installation, mount these relays directly to 35 mm DIN rail (also known as DIN 3 rail). With no moving parts, these solid state relays last longer and require less maintenance, are quieter, and switch faster than mechanical relays.

Install these relays in a panel cutout or plug them into a relay socket. Unlike mechanical relays, these solid state relays have no moving parts, so they require less maintenance and last longer, are quieter, and switch faster.

Provide on/off control for a motor and protect it from overloads. These starters shut the motor off if current exceeds the full-load current rating.

The NEMA 4X rated enclosure protects these starters from corrosion and washdowns.

Use these starters with motors that run forward and backward, such as motors for conveyor belts.

Sealed coils protect these switches against moisture, heat, dirt, and mechanical and thermal stress.