Made of 18-8 stainless steel, these inserts have better corrosion resistance than black-phosphate steel.

A closed-end tap, drill bit, and installation bit are included with these inserts.

Adhesive on both the internal and external threads keeps these inserts in place and holds screws tight.

Made of 18-8 stainless steel, these inserts have good corrosion resistance.

The strongest key-locking inserts we offer, these inserts are made to stringent military specifications.

Eliminating the need for primer, these inserts are coated to resist corrosion when installed in different materials.

A dry film keeps the screw from sticking or binding in these inserts during installation.

These inserts have a high strength-to-weight ratio and resist acids and salt water better than nickel alloy and stainless steel inserts.

A dry film keeps the screw from sticking or binding in these inserts during installation.

Inserts come with a through-hole tap and installation tool.

Without a prong to break off and retrieve, these inserts are often used where debris could cause damage.

A distorted thread grips the screw to resist loosening.

These kits have short-, normal-, and long-reach inserts, an installation tool, and a tap.

These 18-8 stainless steel inserts have better corrosion resistance than brass inserts and may be mildly magnetic.

These aluminum inserts are 70% lighter than brass inserts, electrically conductive, and nonmagnetic. They have good corrosion resistance, which is comparable to brass but not as good as stainless steel.

Made from brass, these inserts are nonmagnetic, corrosion resistant, and electrically conductive.

The flange keeps these inserts from pulling through a hole. Press them in from the underside of material, and install a screw from the top of material.

These 18-8 stainless steel inserts have better corrosion resistance than aluminum inserts and may be mildly magnetic.

Push down on the inside of these inserts with an installation tool and they expand to hold firm in surrounding material.

Assortments include various sizes of inserts, a soldering iron, a ceramic insulation tube, and installation tips.

With the male threaded end on these inserts, mount components directly to plastic parts.

Large threads cut into softwood such as particleboard for a strong hold.

These 18-8 stainless steel inserts have excellent resistance to chemicals and may be mildly magnetic.

Made from brass, these inserts are nonmagnetic, mildly corrosion resistant, and electrically conductive.

Steel inserts have high strength for durability.

Six prongs around the barrel of these inserts provide a strong hold and prevent them from loosening and twisting.

Ridges on the barrel of these inserts make them less likely to split hardwood than inserts with prongs. They're often used in wood that has been cut across the growth rings.

Hooked prongs give these inserts excellent holding power even when removing screws.

A closed end seals out elements and protects the threads on these inserts from debris.

Knurls hold these inserts in hardwoods such as oak, maple, and walnut to prevent twisting.

A wide flange distributes the load over a large area. Hammer these inserts into a drilled hole.