These steel rod ends are machined to SAE standards.

In addition to offering superior chemical resistance, these lightweight, fiber-reinforced nylon rod ends also reduce noise and vibration.

A male-threaded shank lets you build a linkage with a tapped tube or any female-threaded connection.

Connect a clevis rod end to a hydraulic cylinder to create a bend or pivot.

With a small body size, these cylinders fit into tight spaces but offer similar push forces to standard hydraulic cylinders.

Small yet powerful, these cylinders thread into a system for workholding applications.

Push one heavy load while pulling another. These hydraulic cylinders have a rod that runs through both ends, so when it extends on one end, it retracts on the other.

Instead of attaching your round body air cylinder directly to equipment, add a mount to best suit your application.

Push and pull light duty loads. These air cylinders use compressed air to both extend and retract, so they operate at nearly full force in either direction.

More basic and cost effective than double-acting cylinders, these single-acting cylinders exert force in one direction and have a spring to return the rod to its original position.

Unlike other air cylinders that push and pull one object, these double-ended cylinders push one object while pulling another.

Able to resist corrosive solutions and chemical environments, these cylinders withstand washdown conditions.

Simplify your setup by running fluid or air through the hollow piston in these air cylinders. The rod extends from both ends, so they can push an object and pull another at the same time, unlike standard air cylinders.

Minimize the release of particles that can damage electronics or contaminate batches as you push and pull light loads. These air cylinders are designed with seals and caps that prevent particles from escaping.

Move loads between three positions instead of two.

Connect these mounts to an air cylinder to create linear, pivot, or arc movements. These mounts are compatible with NFPA tie rod air cylinders.

Made with an NFPA industry standard footprint and a stainless steel body, these cylinders are easily interchanged with the most common mounting footprint and withstand chemicals, corrosive solutions, and washdowns.

Connect these mounts to an air cylinder to create linear, pivot, or arc movements. These mounts are compatible with ISO tie rod air cylinders.

An extruded-aluminum body means these cylinders have no open spaces for debris to collect. They have an ISO industry-standard footprint to match common mounting patterns for easy interchangeability.

An extruded-aluminum body means these cylinders have no open spaces for debris to collect.

Cylinders have two parallel piston rods that prevent twisting as they extend and retract.