Made of chemical-resistant nylon, these collars are suitable for washdown applications.

Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

Installing and removing a collar is as easy as pushing down and lifting up a clamp lever.

Internal ball bearings allow you to slide a collar onto your shaft in one direction and then automatically lock the collar in place in the opposite direction.

Wider than standard shaft collars with twice the number of clamping screws, these ensure a better grip for greater holding power.

Formed to offset the weight of the clamping screw, these collars won't wobble or vibrate when shafts are spinning—even at high speeds.

An embedded sleeve squeezes the shaft as you tighten the clamping screws, allowing these collars to handle up to three times the thrust load of standard collars.

Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

With larger screws than those found on standard clamping collars, these provide a stronger grip on your shaft without using additional screws.

Wider than standard shaft collars with twice the number of clamping screws, these ensure a better grip for greater holding power.

Although these collars fit inch-sized shafts, they have a metric OD and width for use with metric equipment.

Offering the benefits of a two-piece collar in a one-piece design, these collars swing open for positioning then close anywhere on your shaft.

To install, slide these one-piece collars onto the end of your shaft.

These collars have two different sides—one locks down like a standard clamping shaft collar; the other has a flush face that you can machine to add slots, holes, and grooves to match your special setups.

Mount these collars flush against each other or attach components to either side—the round body has flattened ends with tapped holes.

To install, thread these one-piece collars onto the end of your shaft.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

These threaded handles take the place of a set screw, allowing you to move set screw shaft collars without additional tools—useful for when the collar serves as a stroke limiter or mounting clamp.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

Install these two-piece collars square shafts.

With a nylon insert that grips your threaded shaft or spindle without damaging its threads, these locknuts—also called shaft nuts—hold bearings, bushings, gears, and pulleys prone to vibration tightly in place.

Used in pairs or with another bearing retaining nut, these jam nuts—often called shaft nuts—hold bearings, bushings, pulleys, and gears in place on your threaded shaft or spindle.

Mount these two-piece collars anywhere on an Acme lead screw without removing components.

Half the weight of steel, this aluminum framing resists corrosion in wet environments.