These two-piece supports allow access to the shaft without needing to slide out the shaft or uninstall the support. Use them to brace the end of a linear shaft when working with light to medium loads where shaft alignment is not critical. Tighten the included clamping screws to secure.

Create a support that fits the exact dimensions of your shaft. Good for use with square- and hex-profile shafts, these aluminum supports also work with round shafts of any diameter up to 1". Use them for light-to-medium-load linear motion applications where shaft alignment is not critical.

A removable collar allows access to the shaft without unbolting the flange. For use with light to medium loads where shaft alignment is not critical, these carbon steel supports allow you to hold linear shafts perpendicular to the mounting surface. Secure the shaft by tightening the clamping screw.

At approximately one-third the height of standard versions, these rails provide linear shaft support in applications with low vertical clearance. They provide stability over the entire length of shaft, allow virtually unlimited travel lengths, and eliminate bending under moderate to heavy loads.

Store tools such as brooms, cordless drills, screwdrivers, and flashlights.

Made from FDA listed materials for use in food-processing areas, these easy to clean racks hold multiple items, such as utensils and brushes.

Organize small parts and hand tools with these racks, which attach to steel walls, cabinets, and other magnetic surfaces.

With threads on one end, holders can easily be screwed into a wall.

A locking tab and mounting screw secure holders on hardboard pegboard to store tools such as pliers, screwdrivers, and hammers.

Store tools such as pliers, screwdrivers, and hammers.

Hold steel tools, nails, nuts, screws, and other magnetic items on your pegboard.

These holders keep steel tools in place magnetically.

Brackets mount to the frame of a conveyor to hold mounting rods.

A clamp on one end grips conveyor guides or rods.

The pivoting joint on these rods makes angle-mounting easy.

Use brackets and connectors to create vertical and horizontal support arms.

Fasten these brackets to ceilings, walls, beams, and joists to hang threaded rod.

Install directly into a mounting surface to suspend threaded rod from ceilings and walls.

Attach these clamps to the flange of an beam, then hang a threaded rod from the threaded hole.

Also known as purlin clamps, these clamps are shaped to fit around beams that have a 45° or 90° lip.

For centered load distribution, these clamps grip both sides of the beam and hang threaded rod from the middle.

Support strut channel at a right angle to the beam.

For less waste, these holders grasp the electrode close to the end.

These holders offer more hand clearance than standard stick electrode holders.

Also known as cantilever racks.

Also known as cantilever racks.

With multiple heights, widths, and arm styles to choose from, create a rack that fits your needs. These racks are also known as cantilever racks.

Easily assemble and reconfigure as your needs change.

Made of steel for durability, these trucks have removable rails that allow you to configure them to accommodate a variety of long, flat loads.

These easy-to-clean, corrosion-resistant plastic trucks are reinforced with steel for strength. Removable rails allow you to configure them to accommodate a variety of long, flat loads.

Add wheels to a door, partition, or piece of sheet stock to make moving a one-person job.