This material has tighter tolerances than standard 304 stainless steel.

This material has tighter tolerances than standard 303 stainless steel.

Each piece is precision ground to offer tighter tolerances than standard 17-4 PH stainless steel.

This material is precision ground to offer tighter tolerances than standard 316 stainless steel.

Also known as mild steel, low-carbon steel is easy to machine, form, and weld. It's widely fabricated into parts that don’t require high strength.

Ready for turning in a lathe, these rods are precision ground and held to a strict straightness tolerance.

A lead-free alternative to 12L14, 1215 carbon steel contains the same amount of sulfur and phosphorus for excellent machinability. It is often used for shaft couplings, studs, and pins.

Ready for turning in your lathe, these rods are precision ground and held to a strict straightness tolerance.

The most widely used aluminum, 6061 is fabricated into everything from pipe fittings and containers to automotive and aerospace parts. It is strong and corrosion resistant, plus it's easy to machine and weld.

Ready for turning in a lathe, these rods are precision ground and held to a strict straightness tolerance.

Precision ground and held to a strict straightness tolerance, these rods are ready for turning in your lathe.

With the highest lead content of all the brass alloys, 360 offers the best machinability. Often called free-machining and free-cutting brass, it stands up to high-speed drilling, milling, and tapping operations with minimal wear on your tools. It’s commonly used for gears, pinions, and lock components.

Offering high electrical conductivity and formability, 110 copper is 99.9% pure. Also known as ETP copper, it's often used in electrical applications, such as for bus bars and wire connectors, as well as for flashing, gaskets, and rivets.

Mount these externally threaded shafts into tapped holes rather than using a shaft support, or attach a hex nut, shaft collar, or other threaded accessory.

Lighter than solid shafts, hollow shafts reduce your total system weight and allow you to run various media such as electrical wiring, compressed air tubing, coolants, or lubricants through the center.

Clip retaining rings into the grooves to separate and position collars, supports, and housings.

Combine with a machine key to transmit torque to gears, sprockets, and other power transmission components.

Mount the flange to a machine or wall to support idler sprockets and pulleys in tensioning applications. They include washers and a nut to position your component and hold it in place.

Attach threaded accessories, such as mixer propellers and fan blades, to the end of these shafts.

Clip retaining rings into the grooves to separate and position gears, sprockets, and bearings.