From cookware to chemical-processing equipment, 304 stainless steel is a good all-around choice for a wide range of applications.

Widely used for fabricating fittings and fasteners, 303 stainless steel machines quickly without sticking to cutting tools.

Hardened for improved strength and wear resistance, these rods are precision ground to a strict diameter tolerance. Use them for turning applications in your lathe.

The addition of molybdenum gives 316 stainless steel excellent corrosion resistance. Use it in a variety of marine and chemical-processing applications.

Hardened for superior wear resistance, these rods are precision ground to a tight diameter tolerance so they’re ready for turning in a lathe.

These rods are precision ground and held to a strict straightness tolerance, so they're ready for turning in a lathe.

Often called Stressproof, these rods are stress-relieved to minimize warping during machining.

Stronger than low-carbon steel with equally good machinability, 1045 carbon steel is widely used for bolts, studs, and shafts.

The most widely used aluminum, 6061 is fabricated into everything from pipe fittings and containers to automotive and aerospace parts. It is strong and corrosion resistant, plus it's easy to machine and weld.

Ready for turning in a lathe, these rods are precision ground and held to a strict straightness tolerance.

Precision ground and held to a strict straightness tolerance, these rods are ready for turning in your lathe.

With the highest lead content of all the brass alloys, 360 offers the best machinability. Often called free-machining and free-cutting brass, it stands up to high-speed drilling, milling, and tapping operations with minimal wear on your tools. It’s commonly used for gears, pinions, and lock components.

Offering high electrical conductivity and formability, 110 copper is 99.9% pure. Also known as ETP copper, it's often used in electrical applications, such as for bus bars and wire connectors, as well as for flashing, gaskets, and rivets.

Combine these general purpose shafts with a linear bearing and shaft support to create a basic linear motion system.

Internal threads allow you to mount these shafts onto threaded studs and fasteners, no shaft supports needed.

A shoulder near the end of the shaft allows for easy positioning of housings, shaft supports, and collars.

Use these general purpose shafts with bearings, sprockets, and gears to transmit rotary motion.

Mount the flange to a machine or wall to support idler sprockets and pulleys in tensioning applications. They include washers and a nut to position your component and hold it in place.