A flat surface area allows set screws to dig into the shaft for securely mounting gears, sprockets, and bearings.

Connect these internally threaded shafts directly to threaded components, or use a fastener to secure.

Clip retaining rings into the grooves to separate and position gears, sprockets, and bearings.

Internal threads allow you to mount these shafts onto threaded studs and fasteners, no shaft supports needed.

Clip retaining rings into the grooves to separate and position collars, supports, and housings.

These Grade B7 threaded rods meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges.

About half the strength of medium-strength steel threaded rods, use these for light duty hanging, mounting, and fastening.

Grade B8 threaded rods meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges. They have good chemical resistance.

One-third the weight of steel, aluminum threaded rods resist corrosion in wet environments.

A hex drive on one end allows these rods to be turned with a hex key for ease of installation.

Also known as hood pins, these studs have a cotter pin lodged through a drilled hole in the unthreaded portion for light duty holding, such as securing access panels and locking other fasteners.

Made from Grade 5 steel, these inch-sized coupling nuts are suitable for most applications.

These coupling nuts have good chemical resistance.

Brass coupling nuts are corrosion resistant in wet environments and electrically conductive.

Use the sight hole to check for proper thread engagement.

Connect two differently sized male-threaded parts, such as threaded rods, and tighten with a standard wrench.