A flat surface area allows set screws to dig into the shaft for securely mounting gears, sprockets, and bearings.

Connect these internally threaded shafts directly to threaded components, or use a fastener to secure.

A shoulder near the end of the shaft provides a stop for gears, sprockets, and bearings.

Internal threads allow you to mount these shafts onto threaded studs and fasteners, no shaft supports needed.

Clip retaining rings into the grooves to separate and position collars, supports, and housings.

These Grade B7 threaded rods meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges.

Grade B16 threaded rods maintain their strength at higher temperatures than Grade B7 threaded rods. They meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges.

Tighten these threaded rods by turning them to the left; once fastened, they resist loosening from counterclockwise motion. About half the strength of medium-strength steel threaded rods, use them for light duty hanging, mounting, and fastening.

Grade B8 threaded rods meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges. They have good chemical resistance.

More corrosion resistant than 18-8 and 410 stainless steel threaded rods, these 316 stainless steel rods have excellent resistance to chemicals and salt water.

Brass threaded rods are corrosion resistant in wet environments, electrically conductive, and nonmagnetic.

The left-hand threads on these coupling nuts resists loosening from counterclockwise vibration. Use in light duty applications.

Made from Grade 8 steel, these nuts are about 25% stronger than medium-strength steel coupling nuts. Furnished in inch thread sizes.

These coupling nuts have good chemical resistance.

One-third the weight of steel, aluminum coupling nuts resist corrosion in wet environments.

Connect two differently sized male-threaded parts, such as threaded rods, and tighten with a standard wrench.