Search Results
    Clear All
    System of Measurement
    System of Measurement
    Metric
    Material
    Material
    Steel
    Specifications Met
    Specifications Met
    Thread Size
    Thread Size
    Show
    Thread Pitch
    Thread Pitch
    Thread Type
    Thread Type
    Metric
    UNC
    Threading
    Threading
    Fully Threaded
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Thread Direction
    Thread Direction
    Hardness
    Hardness
    Rockwell B49
    Not Rated
    Tensile Strength
    Tensile Strength
    50,000 psi
    Not Rated
    Thread Fit
    Thread Fit
    Class 6g
    Thread Spacing
    Thread Spacing
    click to learn more about
    Base Diameter
    Base Diameter
    default
    5.7mm
    7mm
    Finish
    Finish
    Zinc Plated
    Drill Bit Decimal Size Equivalent
    Drill Bit Decimal
    Size Equivalent
    0.138"
    PEM® Part Number
    PEM® Part Number
    FH-M3.5-6
    FH-M3.5-8
    FH-M3.5-10
    FH-M3.5-12
    Base Thickness
    Base Thickness
    1.1mm
    For Hole Diameter
    For Hole Diameter
    3.5mm
    For Minimum Length Between Hole Center and Sheet Edge
    For Minimum Length
    Between Hole Center
    and Sheet Edge
    6.5mm
    Projection Location
    Projection Location
    Above Head
    For Minimum Material Thickness
    For Minimum
    Material Thickness
    1.000mm
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)

    9 Products