Internal threads allow you to mount these shafts onto threaded studs and fasteners, no shaft supports needed.

Clip retaining rings into the grooves to separate and position collars, supports, and housings.

Mount the flange to a machine or wall to support idler sprockets and pulleys in tensioning applications. They include washers and a nut to position your component and hold it in place.

Connect these internally threaded shafts directly to threaded components, or use a fastener to secure.

A flat surface area allows set screws to dig into the shaft for securely mounting gears, sprockets, and bearings.

A shoulder near the end of the shaft provides a stop for gears, sprockets, and bearings.

Class 12.9 rods are about 20% stronger than Class 10.9 threaded rods and are for use in heavy machinery.

These metric Grade B7 threaded rods meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges.

These metric threaded rods are about half the strength of medium-strength steel threaded rods for light duty hanging, mounting, and fastening.

These metric threaded rods tighten when turned to the left; once fastened, they resist loosening from counterclockwise motion. About half the strength of medium-strength steel threaded rods, use them for light duty hanging, mounting, and fastening.

These metric 316 stainless steel threaded rods are more corrosion resistant than 18-8 and 410 stainless steel threaded rods and have excellent resistance to chemicals and salt water.

Unlike metal rods, these metric threaded rods will not warp at extreme temperatures, making them ideal for heat treating and furnace fixtures.

These metric brass threaded rods are corrosion resistant in wet environments, electrically conductive, and nonmagnetic.

Screw the threaded end of these metric studs into a tapped hole and use the unthreaded end as a pivot point, hinge, shaft, or locator pin.

These steel studs are zinc plated to resist corrosion in wet environments.

316 stainless steel studs have excellent resistance to chemicals and salt water.

More corrosion resistant than 18-8 stainless steel coupling nuts, these metric nuts have excellent resistance to chemicals and salt water.

Choose these locknuts to fasten standard metric threads. They’re Class 8 steel, so they can be used in most fastening applications.

One-third the weight of steel, aluminum coupling nuts resist corrosion in wet environments.

Stainless steel coupling nuts have excellent corrosion resistance in most environments.

Increase or decrease metric thread size from one male-threaded part to another. Commonly used to connect two differently sized threaded rods, they have a hex-shaped body, so you can tighten them with a standard wrench.

Also known as single-start and self-locking lead screws and nuts, these have a single thread that runs the length of the screw. The nut travels only when the screw turns, so your system won't unexpectedly move when the lead screw is at rest.

Designed for use with right-hand, externally threaded rod ends, these rods have right-hand threads on both ends. Use them for remote valve operators, throttle controllers, shifting mechanisms, and virtually any push/pull assembly.

Similar to turnbuckles, these rods have right-hand threads on one end and left-hand threads on the other so you can make a linkage that adjusts for tension.

Also known as tap-end and fixture studs, these rods have friction-fit threads on one end to resist loosening and standard threads on the other side for attaching a nut.

Made from stainless steel for excellent corrosion resistance in damp environments.

Thread these ball socket end fittings onto gas springs. They rotate in any direction on a ball stud to compensate for misalignment.

These end fittings snap right on a ball stud—an integral retaining clip grips the ball stud for secure attachment until you apply enough force to pop it off.