Also known as eccentric track rollers, the shoulder adjusts up or down to align to your track, enabling uniform alignment among rollers in a system. Secure the stud with a nut for through-hole mounting. All rollers have end seals to protect rolling elements from dirt and contamination.

Crowned rollers have a slight curve, which is invisible to the naked eye, to stay centered on surfaces that are not perfectly aligned and/or not perfectly flat.

For technical drawings and 3-D models, click on a part number.

Also known as yoke-style cam followers, these rollers have more mounting flexibility than threaded track rollers. They're typically mounted onto a shaft or clevis rod end. Lubricate rollers through a hole and groove in the inner ring.

Crowned rollers have a slight curve, which is invisible to the naked eye, to stay centered on surfaces that are not perfectly aligned and/or not perfectly flat.

Rollers with seal have end seals to protect rolling elements from dirt and contamination.

For technical drawings and 3-D models, click on a part number.

Install these rollers in worn-out mounting holes or where you don’t have access to the back of the mounting hole. The stud is tapered, so you can quickly secure them in place with a set screw (not included) instead of a nut on the back like traditional rollers. Keep in mind, this reduces their radial capacity.

Rollers with a seal protect rolling elements from dirt and contamination better than shielded rollers, but they do hold more heat. The seal also helps retain lubrication.

Add a grease fitting to create a lubrication point.

For technical drawings and 3-D models, click on a part number.

Thread the stud directly into a component or secure with a nut for through-hole mounting. Rollers are for use with Angle Rails for V-Groove Track Rollers. They handle radial and thrust (top and side) loads and work well in dirty environments because debris falls off the angled rail. Also known as cam followers, track rollers support loads while guiding and positioning work. All rollers are permanently lubricated.

440C stainless steel rollers offer better corrosion resistance than steel rollers.

Rollers with a plastic overmold make less than noise than other rollers, and they’re suitable for corrosive environments. However, they have lower weight capacities than other similarly sized rollers and they’re less corrosion resistant than other stainless steel rollers.

Rollers with a seal block out dust and other contaminants better than shielded rollers, but they hold more heat. Their seal also helps retain lubricant.

For technical drawings and 3-D models, click on a part number.

Also known as eccentric track rollers, the shoulder adjusts up or down to align to your track, enabling uniform alignment among rollers in a system. Rollers are for use with Angle Rails for V-Groove Track Rollers. They handle radial and thrust (top and side) loads and work well in dirty environments because debris falls off the angled rail. Secure the stud with a nut for through-hole mounting. All rollers are permanently lubricated.

440C stainless steel rollers offer better corrosion resistance than steel rollers.

Rollers with a plastic overmold make less noise than other rollers, and they’re suitable for corrosive environments. However, they have lower weight capacities than other similarly sized rollers and they’re less corrosion resistant than other stainless steel rollers.

Rollers with a seal block out dust and other contaminants better than shielded rollers, but they hold more heat. Their seal also helps retain lubricant.

For technical drawings and 3-D models, click on a part number.