This polypropylene rope floats in water, resists rot, and doesn’t lose strength when wet. It also resists acid, oil, and gas. The twisted construction gives rope a grooved surface, allowing you to grip it tight without it slipping.

Note: The safety factor for capacity is 12:1.

Use this nylon rope when you need to compensate for sudden force, such as in towing applications or dock lines. It is rot and mildew resistant. When wet, the rope can lose up to 20% of its strength. The twisted construction gives this rope a grooved surface, allowing you to grip it tight without it slipping.

Note: The safety factor for capacity is 12:1.

Made of twisted, soft cotton, this rope is gentle on your hands and has a grooved surface that's easy to hold tight.

Note: The safety factor for capacity is 12:1.

Softer than all other sure-grip rope, this manila rope is more comfortable to grip. Its twisted construction gives it a grooved surface, so you can grip it tight without it slipping.

Note: The safety factor for capacity is 12:1.

The rough texture of this sisal rope allows it to make tight and long-lasting knots. It has a twisted construction that makes it easy to hold tight without slipping.

Note: The safety factor for capacity is 12:1.

A coarse, natural texture makes this rope easier to grip than other wet-environment rope. Rope floats in water, resists rot, and doesn’t lose strength when wet. It also resists acid, oil, and gas, and knots easily.

Note: The safety factor for capacity is 12:1.

Also known as truck tie-down rope, this rope has added UV-ray inhibitors to protect it from deterioration when used outdoors. Rope is polypropylene so it floats in water, resists rot, and doesn’t lose strength when wet. It also resists acid, oil, and gas. The twisted construction gives rope a grooved surface, allowing you to grip it tight without it slipping.

Note: The safety factor for capacity is 12:1.

Made of a polyester/polypropylene blend, this rope is approximately 15% lighter than standard polyester rope. Use it for applications that require minimal stretch, such as in tie-down applications. It resists UV rays, rot, oil, and gas, and will not lose strength when wet. The twisted construction gives it a grooved surface, allowing you to grip it tight without it slipping.

Note: The safety factor for capacity is 12:1.

These must be oriented with the saddle on the long (live) end and U-bolt on the short (dead) end. Their forged fabrication makes these clamps more reliable in critical applications such as tie downs and support lines. They’re also known as wire rope clips. Clamps have a thick coating for corrosion resistance.

Warning: Test all assemblies for required strength before use. Do not use with coated rope unless the coating is removed.

Adjust the length by attaching the hook into a slot in the strap. With the strength of plastic and the stretch of rubber, these bungee cords have excellent stretch recovery and won't become brittle. They stand up to oil, grease, fuel, ozone, and salt water.

Warning: Never use for lifting applications.

Also known as open wedge sockets, these end fittings require only a torque wrench to install. To install, wrap the wire rope around the removable wedge before securing it inside the body. A wire rope clamp attached through the top hole in the wedge secures the short (dead) end.

Two additional holes at the bottom of the wedge can be used as a "go/no go" gauge to determine the proper rope size. The wire rope should pass through the "go" hole and not through the "no go" hole.

Warning: Fittings must match rope diameter and be installed correctly to obtain maximum holding power. Test all assemblies for required strength before use. Do not use with coated rope unless the coating is removed.

This cord won't become brittle or hard after exposure to sunlight. Also known as bungee cord and shock cord, a polypropylene cover protects the inner elastic from abrasion. Use by itself or add fittings to create a complete bungee cord. It stretches up to 1.5 times its length.

Warning: Never use for lifting applications.

These clamps apply equal pressure without crimping or crushing the wire rope, so orientation doesn't matter. They provide a saddle for both the long (live) and the short (dead) end of the wire rope. Their forged fabrication makes these clamps more reliable in critical applications such as tie downs and support lines. Also known as fist grip wire rope clips.

Warning: Test all assemblies for required strength before use. Do not use with coated rope unless the coating is removed.

Made of 316 stainless steel, these clamps are corrosion resistant. They must be oriented with the saddle on the long (live) end and U-bolt on the short (dead) end. Their forged fabrication makes these clamps more reliable in critical applications such as tie downs and support lines. They’re also known as wire rope clips.

Warning: Test all assemblies for required strength before use. Do not use with coated rope unless the coating is removed.

The ends of these slings are woven back into the sling, reducing the chance of the sling catching when lifting a load. They include a tag that shows capacities in each configuration.

Warning: Never use to lift people or items over people.

Kits include clamps and thimbles to protect the inside of wire rope loops from fraying. Clamps must be oriented with the saddle on the long (live) end and U-bolt on the short (dead) end. Warning: Test all assemblies for required strength before use. Do not use with coated rope unless the coating is removed.