Slide one of these transmitters onto a motor shaft in your application—they have a flexible mounting plate that compensates for shaft misalignment and vibration. Also known as encoders, these miniature transmitters convert rotary motion to an electrical signal that indicates distance, direction, and speed of travel. They're often used to automate servomotors, robotics, and assembly machines.

Transmitters have NPN Open Collector output that requires a pull-up resistor (not included) for operation. Output channel Z is also known as an index channel. You must use transmitters with a controller that has quadrature detection to get a 4X resolution increase. All meet IP64 for protection from dust and water spray.

Often used with servomotors, these transmitters have a mounting hole pattern that fits a three-hole 28 mm BC servomotor face. Also known as encoders, these miniature transmitters convert rotary motion to an electrical signal that indicates distance, direction, and speed of travel. They're commonly used in control systems to automate servomotors, robotics, and assembly machines.

Transmitters have NPN Open Collector output that requires a pull-up resistor (not included) for operation. Output channel Z is also known as an index channel. You must use transmitters with a controller that has quadrature detection to get a 4X resolution increase. All meet IP64 for protection from dust and water spray.

Use a flexible shaft coupling (not included) to connect the transmitter shaft to a drive shaft.

Wire these counters up to an electrical pulse-emitting switch, sensor, or encoder for use on machine tools, packaging machinery, or other equipment. They have two displays. One display shows a set point and the other counts incoming pulses. When the counter reaches the set point, an output relay sends a signal to another device. The signal can start/stop a process or trigger an alarm.

For technical drawings and 3-D models, click on a part number.

For quick installation, this counter fits standard DIN panel cutouts. Wire it up to an electrical pulse-emitting switch, sensor, or encoder for use on machine tools, packaging machinery, or other equipment. An output relay sends a signal to another device when the counter reaches a set point. The signal can start/stop a process or trigger an alarm. A gasket provides protection from direct water sprays (meets IP65). UL Recognized Component, C-UL Recognized Component, and CE marked, this counter meets American, Canadian, and European safety standards.

For quick installation, these counters fit standard DIN panel cutouts. Wire them up to an electrical pulse-emitting switch, sensor, or encoder for use on machine tools, packaging machinery, or other equipment.

Press-on counters have a front panel that is rated NEMA 4 and IP66 for protection against dust and washdowns and outdoor use. The screw terminals are rated IP20.

Screw-on counters are rated NEMA 4X, NEMA 12, and IP65 for protection against dust, water, and splashing oil and coolant.

Counters with backlit display have good visibility in low-light conditions.

For technical drawings and 3-D models, click on a part number.

This counter does not require voltage to register a count. It is protected from dust and washdowns and can be used outdoors (rated NEMA 4).

For technical drawings and 3-D models, click on a part number.

You can set these counters up to count with or without voltage inputs based on the switch, sensor, or encoder you have. Count backup maintains the count if power is lost. A scaling function lets you adjust the unit of measure to suit your application.

For technical drawings and 3-D models, click on a part number.