Select these bumpers for applications that require specific load capacities. All are reinforced with a base plate for strength. Often used as feet, spacers, and vibration dampers, they absorb shock to prevent damage to equipment and surfaces. They're also good for starting and stopping motion on automated machines and conveyors. Twist these bumpers into a threaded hole.

These bumpers withstand temperatures up to 300° F, which is twice as high as our other load rated bumpers. Use them in applications that require specific load capacities. All are reinforced with a base plate for strength. Often used as feet, spacers, and vibration dampers, these bumpers absorb shock to prevent damage to equipment and surfaces. They're also good for starting and stopping motion on automated machines and conveyors. Twist them into a threaded hole.

Select these bumpers for applications that require specific load capacities. All are reinforced with a base plate for strength. Often used as feet, spacers, and vibration dampers, they absorb shock to prevent damage to equipment and surfaces. They're also good for starting and stopping motion on automated machines and conveyors. Mount these bumpers on a threaded stud.

Push the stem into a hole for quick installation. These bumpers are commonly used as feet on instruments and bench-top equipment to keep them from sliding. They're also good as spacers between sheets of material. Also known as stem and grommet bumpers.

A ridge on the stem provides a tighter grip than other push-in bumpers. Push the stem into a hole for quick installation. These bumpers are commonly used as feet on instruments and bench-top equipment to keep them from sliding. They're also good as spacers between sheets of material. Also known as stem and grommet bumpers.

All of these bumpers are reinforced with an embedded washer or base plate for strength. Often used as feet, spacers, and vibration dampers, they absorb shock to prevent damage to equipment and surfaces. They're also good for starting and stopping motion on automated machines. Install them with screws.

Press these bumpers into place with the adhesive backing. Use them as feet and spacers on instruments and small appliances to limit sliding, vibration, and noise. They're comparable to Bumpon bumpers.

Made of neoprene rubber, these feet are a good choice for use in oily environments.

A two-piece design simplifies installation and requires less clearance than one-piece mounts.

Higher deflection ratings translate to greater vibration and shock isolation.

A two-piece design requires less clearance than one-piece mounts and simplifies installation—raise your machine just enough to slide the base underneath, then insert the stud from above.

Higher deflection ratings translate to greater vibration and shock isolation.

A two-piece design makes these mounts easier to install than one-piece mounts.

Specifically designed for light vertical loads, these mounts buckle to protect lightweight equipment such as small fans and pumps from vibration.

Designed for tight spaces such as inside machinery, these mounts fit into a cutout, so they so they have a low top profile.

Well-suited to moist environments, these mounts have a stainless steel plate for excellent corrosion resistance.

Made of nitrile rubber, these mounts are oil resistant for use in compression load applications with punch presses, milling machines, grinders, and air compressors.

Limit damage during moderate earthquakes.

Connect these mounts to your air supply for vibration and shock isolation in compression load applications.

An economical choice for applications in corrosive environments that don't require high load capacities, these mounts have a plastic base.

Well-suited to damp environments, these mounts have a stainless steel nut for excellent corrosion resistance.

Yellow zinc-plated steel is more corrosion resistant than nickel-plated steel.

Black-oxide steel has a dull shine for areas where appearance is a concern.

Made of 303 stainless steel, these metric mounts resist corrosion from water and most chemicals.

Punch-out holes in the base let you bolt down these mounts to keep your equipment stationary.

Punch-out holes in the base let you bolt down these metric mounts to keep your equipment stationary.

Well-suited to damp environments, these mounts have a stainless steel stud and nut for corrosion resistance.

Bolt these pads into a ladder's front legs to add slip resistance.