Also known as safety pins, these are easy to install and remove. Tension keeps them closed.

A coil makes a stronger grip than standard hairpin cotter pins to prevent accidental release.

Slide the pin through a hole then snap the ring down to lock these pins in place. Also known as click pins.

The double-head design lets you push or pull these pins from either side of the hole. Once in place there's little chance they will be vibrated out or knocked off.

Slide these heavy duty pins into the through-hole in a clevis pin, then hit them with a hammer to wedge the prongs open.

The wire retainer snaps closed to secure the pin for a one-piece alternative to a clevis and cotter pin combination. Also known as PTO pins.

Often used to connect equipment to a drawbar in towing applications, these rugged pins have a welded solid steel retainer.

Clip these pins onto grooved shafts and clevis pins to keep components in place.

Also known as split pins, these have one prong slightly longer than the other so they’re easy to open.

A lock slides upward over the latch to lock. The latch opens outward to accept large diameters of rope.

Also known as quick links, these links thread closed by hand or with a wrench.

The twisted shape of these links prevents loads from rotating or knotting.

Use for three-sided connections. Flat sides ensure webbing and strapping lay flat, so they won't slide and bunch.

Squeeze the trigger to quickly release the latch.

A wide opening accepts large diameters of rope and pipe. Squeeze the trigger to release.

Attach to the arm of a bucket truck.

These harnesses have leather-insulated metal components and meet ASTM F887 when used with an arc flash-resistant lanyard.

Made of heat-resistant Nomex, these harnesses withstand temperatures up to 700° F.

With D-rings on the shoulders, these harnesses allow you to raise and lower workers.

Made of Kevlar, these lanyards meet ASTM F887 when used with an arc flash-resistant harness.

Made of steel, these durable lanyards hold up in abrasive and high-heat applications.

A quick-stop lanyard must be used when you have less than 18 1/2 ft. of fall clearance as it will stop your fall within a few inches.