These rolls can be cut to length.

These sheets resist deterioriation when used wet or with grease, chemicals, cutting fluids, and other solvents that may be present when sanding.

A coating prevents dust and debris from building up on the abrasive surface.

These cut-to-length rolls resist deterioration when used wet or with grease, chemicals, cutting fluids, and other solvents that may be present when sanding. A layer of mesh lets sanding dust and debris escape during use, preventing material buildup on the abrasive surface.

Create consistent finishes on stainless steel, titanium, steel, iron, and nickel.

Create consistent finishes on stainless steel, titanium, steel, iron, and nickel.

Quickly attach, remove, and reuse these hook-and-loop sheets with triangular detail sanders.

A coating prevents dust and debris from building up on the abrasive surface.

The premium abrasive stays sharp longer.

The cushioned construction gives you more control over sanding pressure, creating finer and more consistent finishes.

The premium abrasive lasts longer as well as cuts faster and produces a more consistent finish than standard hook and loop discs.

Quickly attach, remove, and reuse these discs with a compatible sanding tool or backup pad.

The cushioned construction gives you more control over sanding pressure, creating finer and more consistent finishes.

Holes allow dust removal when used with a vacuum sander.

The premium abrasive stays sharp longer.

These belts resist deterioration when used with water or cutting fluids.

Use these narrow belts on hand-held sanding sticks.

The flaps are slit into narrow strips to provide more flexibility than other flap wheels.

The threaded stud allows faster wheel changes but requires the use of an adapter in your tool.

Flexible flaps reduce gouging while producing a uniform finish on flat and curved surfaces. They provide more control than a standard sanding sleeve but are more aggressive than a traditional flap wheel. As the flaps wear, new abrasive is exposed.

Choose a bit with the same angle as your countersink to debur the inside of the hole.