These cut-to-length rolls resist deterioration when used wet or with grease, chemicals, cutting fluids, and other solvents that may be present when sanding.

Press onto a compatible sanding tool or backup pad; peel off to remove.

A special fastener on the back of these discs allows you to easily swap one disc for another.

These discs have a harder abrasive than standard quick-change discs.

Fit these discs over your tool's arbor.

A coating prevents dust and debris from building up on the abrasive surface.

Fit these discs over your tool's arbor to sand masonry, ceramics, and composites.

A coating prevents dust and debris from building up on the abrasive surface.

Fit these discs over your tool’s arbor to sand stainless steel and hard metals.

With more flaps than standard discs, these last 30-40% longer.

With more flaps than standard discs, these last 30-40% longer.

A heavy duty backing plate provides more support than standard discs for heavy material removal.

Set at an angle and widely spaced, the overlapping abrasive flaps reach into corners.

With more flaps than standard discs, these last 30-40% longer.

Set at an angle and widely spaced, the flaps reach into corners.

Use with commercial floor buffing machines to sand wood floors and strip tape from concrete.

These belts resist deterioration when used with water or cutting fluids.

Shape, debur, and sand edges and internal surfaces.

A coating prevents dust and debris from building up on the abrasive surface. These sleeves shape, deburr, and sand edges and internal surfaces.

Flexible flaps reduce gouging while producing a uniform finish on flat and curved surfaces. They provide more control than a standard sanding sleeve but are more aggressive than a traditional flap wheel. As the flaps wear, new abrasive is exposed.