These scaffolds provide the space and height to complete elevated projects that most work platforms can't reach. Each scaffold requires three planks (sold separately). Scaffolds are only OSHA compliant when used with two or more planks on a work level.

Note: Scaffolds meet OSHA dimensional standards. Users are responsible for checking local, state, and federal codes, including OSHA, for safe installation and operating practices.

For technical drawings and 3-D models, click on a part number.

Even if your surface isn't level, your scaffold can be—the end frames on these scaffolds adjust independently so you can set each side at a different height. You can change the plank height in 4" increments; use the spring-loaded pins to lock it in place.

Base sections have positioning guides that hold the plank within the frame. Sections roll on four locking swivel casters; install base plates (sold separately) when used on stairs. Do not stack more than two add-on height sections per base section.

Guardrail/toeboard kits are required by OSHA when add-on height sections are used.

Outriggers are required by OSHA when add-on height sections are used. They extend the base by 20" per side.

Note: Scaffolds meet OSHA dimensional standards. Users are responsible for checking local, state, and federal codes, including OSHA, for safe installation and operating practices.

For technical drawings and 3-D models, click on a part number.

Aluminum is a good choice for damp areas and outdoor use. Hooks with a 2" opening at each end secure planks to end frames. Rungs on the underside are for use as hand grips. Planks have a perforated surface for slip resistance and to reduce debris buildup. End hooks are offset to allow for continuous planking of large scaffolds.

Note: Length is measured from center-to-center of end hooks.

Note: Planks meet OSHA dimensional standards. Users are responsible for checking local, state, and federal codes, including OSHA, for safe installation and operating practices.

Hooks with a 2" opening at each end secure planks to end frames. Rungs on the underside are for use as hand grips. Plywood is 1/2" thick.

Note: Length is measured from center-to-center of end hooks.

Note: Planks meet OSHA dimensional standards. Users are responsible for checking local, state, and federal codes, including OSHA, for safe installation and operating practices.

Create catwalks, bridges, gangways, and mezzanines by combining these planks, guardrails, and toeboards. They also work well between trestles, ladder jacks, and ladder scaffolding supports. Rungs on the underside are for use as hand grips.

Planks have a slip-resistant surface for sure footing. The vinyl end caps protect against sharp edges and act as hand grips.

Guardrails mount to either side of the plank with the upper rails 38" to 42" above the plank surface.

Toeboards mount to either side of the plank. They clamp to guardrail posts.

Note: Planks, guardrails, and toeboards meet OSHA dimensional standards. Users are responsible for checking local, state, and federal codes, including OSHA, for safe installation and operating practices.

For technical drawings and 3-D models, click on a part number.