When you don't have exact alignment between the fastener and the bit, the ball end allows angled entry to turn screws in hard-to-reach areas. A retaining ring grips inside the recess to hold screws in place.

A retaining ring grips inside the recess to hold screws in place. These bits have a ball end that allows angled entry to drive screws in hard-to-reach areas.

The slightly tapered tip wedges into the screw recess for a secure hold. These are also known as Torx-Align bits.

A magnetic ring at the end of the adapter holds flat-head screws in place to ensure good contact between the bit and screw. Use these adapters to hold hex-shank bits (also known as insert bits) in powered tools.

Keep bits from slipping. Insert a bit into the adapter, place a screw on the end of the bit, and slide the adapter sleeve over the screw. The sleeve retracts as the screw is driven. These adapters hold hex-shank bits (also known as insert bits) in powered tools.

Use hex-shank bits (also known as insert bits) in powered tools.

Lock your bit into the adapter to prevent accidental disengagement. These adapters attach to square-drive tools.

Eliminate the need for multiple bulky tools with these bit adapters. At less than 3 inches long, these compact adapters convert ¼” bit screwdriver handles and ¼” bits into torque screwdrivers so you can fasten to a specific torque.

Designed to withstand high torque and force, these adapters fit the square drive on impact wrenches. Use with hex-shank bits (also known as insert bits).

A ratchet mechanism turns fasteners more quickly than a standard bit driver. Insert a bit into the shaft and a magnet holds it in place.

Insert a bit into the shaft and a magnet holds it in place.

Lock the bit into the chuck to prevent accidental disengagement.

Also known as ESD-safe bit screwdrivers, the handle drains static away from your application, preventing buildup from electrostatic discharge (ESD) that can damage sensitive equipment.

An insulated handle and shaft protect against shock from accidental contact with live electrical circuits. These tools are tested to 1,000 volts to meet EN 60900 and IEC 60900.

When working in tight spaces, these short drivers fit where others can't. Bits have a different tip at each end and snap into the shaft, which is also a nutdriver.