Rapidly heat water in small containers to prevent freezing or generate steam. Compact in size, these heaters fit in openings that are 1 ¼ NPT or smaller. With a high-watt density, they heat liquids up quickly. Inside the sheath is a heating element made of Incoloy or 316 stainless steel that won’t corrode when exposed to water and moisture.

Both ends of the fitting are threaded, so one side fits into your tank and the other can be threaded into conduit to protect the wiring. For the most even heat distribution, choose the largest length of heater that will fit in your container. All require a temperature switch or controller (sold separately) to regulate the heat output and power the heater.

Note: Fully immerse the heating element in liquid to prevent heater failure.

Heat water through direct contact in sanitary areas such as food, cosmetic, and pharmaceutical plants. Made of 316 stainless steel, these immersion heaters won’t corrode from harsh cleaners and sanitizers. To minimize bacteria growth and make them easier to clean, the heating element has an electropolished finish that’s free of crevices. Rated NEMA 4, their housing is protected against dirt and washdowns.

These heaters have screw plugs for mounting to threaded container openings or pipe couplings.

Heaters with an adjustable thermostat automatically turn on when the water drops below a set temperature and turn off once it reaches that temperature. Heaters without an adjustable thermostat require a temperature switch or controller (not included) to control heat output.

Note: Fully immerse the heating element in liquid to prevent heater failure.

To heat oil and coolant without creating hot spots and damaging the heating element, these heaters have a lower watt density than heaters for water or chemicals. They install into threaded container openings or pipe couplings to quickly and efficiently heat liquid through direct contact.

Heaters without temperature control require a temperature switch or controller (sold separately) to regulate heat output.

Heaters with an adjustable thermostat automatically turn on when the temperature drops below the set temperature and off when it rises above the set temperature. Adjust the set temperature with the dial.

Incoloy heating elements are more corrosion resistant than steel heating elements.

Note: Fully immerse the heating element in liquid to prevent heater failure. These heaters install through threaded container openings or pipe couplings.

Heat oil or coolant inside small containers to reduce the viscosity of the liquid and improve flow. These heaters fit in compact openings that are 1 NPT or smaller. With a low-watt density, these heaters operate efficiently and won’t burn out when used with a wide range of oils and coolants. The heating element is made of stainless steel, so it resists corroding when exposed to chemicals.

Both ends of these heaters are threaded, so one side fits into your tank and the other can be threaded into a conduit to protect the wiring. For the most evenly distributed heating, choose the largest length of heater that will fit in your container. To control the settings of the heater, they must be connected to a temperature switch or controller (required but not included).

Note: Fully submerge the heating element in liquid to prevent heater failure.

Install these heaters into threaded container openings or pipe couplings to quickly and efficiently heat liquid through direct contact. The heating element is Incoloy for excellent resistance to harsh chemicals.

Heaters without temperature control require a temperature switch or controller (sold separately) to regulate heat output.

Heaters with an adjustable thermostat automatically turn on when the temperature drops below the set temperature and off when it rises above the set temperature. Adjust the set temperature with the dial.

Note: Fully immerse the heating element in liquid to prevent heater failure.