These standoffs are made to NAS specifications.

Protect components from electrical charges.

Secure computer cables and panels.

These standoffs are designed to fit in the limited space of compact electronics such as laptops and hand-held devices.

Once the end is clinched in place, panels with keyholes easily slide on and off these supports.

Thread the male connection into a tapped hole and snap the other end into a panel for a secure hold that can be released for repairs and upgrades.

Designed for multi-level printed circuit board applications, these self-aligning, through-hole supports have a chamfered female end for stacking. The other end snaps and locks in place for a permanent connection.

The ends of these removable supports snap in and compress between panels to reduce vibration of miniature cooling fans in compact electronics.

Secure the self-tapping female connection with a screw; the other end snaps snugly into a panel, yet can be released for repairs and upgrades.

In addition to joining male- and female-threaded parts, these adapters can increase or decrease metric thread sizes and change the thread pitch.

The through hole allows you to connect float rods to float valves.

Twist these adapters onto female metric threads to change pitch or switch thread sizes.

Join two female-threaded parts of various thread types and sizes, while allowing air, liquids, wire, or other thin materials to pass through.

Slide these shims under the screw head to shorten the shoulder length.

For a snug fit around a shaft, the ID of these shims is held to a tighter tolerance than other round shims.

Be prepared with ring shims in a variety of thicknesses. These shims fit around fasteners and shafts to precisely align, level, and adjust spacing.

Be prepared with ring shims in a variety of thicknesses. These shims are color-coded by thickness for easy identification.

Also called tolerance rings, these rings are for use in stamped, molded, or worn housings to form a tight hold on the bearings.

Place these shims under sharpened dies to restore their original height and extend their life.

Use round shims to precisely align, level, and adjust spacing on shafts and machinery.

Place these shims under sharpened dies to restore their original height and extend the life of the dies.