When you don't have exact alignment between the fastener and the tool, the ball end allows angled entry to turn screws in hard-to-reach areas.

These standard nutdrivers have a hollow shaft that provides clearance to remove nuts from long bolts.

Sets include an assortment of drivers that are drilled all the way through the shaft and handle for turning nuts on any length of threaded rod. They have a magnet in the tip to hold nuts in place.

Press down on the handle’s collar to adjust the shaft length or remove and replace the shaft to change sizes. Sets include a handle and multiple shafts.

The assorted drivers in these sets have an insulated handle and shaft that protect against shock from accidental contact with live electrical circuits. They are tested to 1,000 volts to meet ASTM and IEC standards.

Protect your stainless steel fasteners by using a stainless steel driver. If steel flakes off a standard tool and into the threads, it can lead to rust and contamination. These drivers eliminate that risk.

A magnet or retaining ring holds the nut in place.

Because they make contact on the flat sides of fasteners rather than only on the corners, these magnetic bits significantly reduce slipping and stripping. They’re also known as lobular bits.

Assortments contain bits with multiple drive styles.

Turn fasteners from either end and reach into tight spots.

These assorted keys have a ball end that allows angled entry to make good contact with the screw recess when standard-tip keys can’t. Use to turn screws in hard-to-reach spots.

With a simple loop handle, these keys are the economical choice. They have a long shaft for reaching into tight spots and the T-handle provides a good grip for your whole hand when turning fasteners.