We will reply to your message within an hour.
The standard for high-strength fastening.
Made from Grade 8 steel, these screws can be used in high-stress applications, such as valves, pumps, motors, and automotive suspension systems. They are at least 25% stronger than medium-strength steel screws.
Twice as strong as low-strength steel screws, these screws are suitable for fastening most machinery and equipment.
Use these general purpose 18-8 stainless steel screws for a variety of fastening applications. They have good chemical resistance.
Made from alloy steel, these inch size set screws have a thin edge that digs into hard surfaces for a secure hold.
Also known as jam set screws, these lock other screws in place, hold pins, and adjust spring tension. A black-oxide finish provides corrosion resistance in dry environments.
Grade B7, these threaded rods have a tensile strength about one and a half times stronger than low-strength steel rods. They meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges.
Tighten these threaded rods by turning them to the left; once fastened, they resist loosening from counterclockwise motion. Made from Grade B7 steel, their tensile strength is one and a half times higher than low-strength steel rods.
Comparable to Grade 8 steel, these threaded rods have a tensile strength of 150,000 psi, making them about 25% stronger than medium-strength steel rods.
About half the strength of medium-strength steel threaded rods, use these for light duty hanging, mounting, and fastening.
18-8 stainless steel threaded rods have good chemical resistance.
Grade B8 threaded rods meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges. They have good chemical resistance.
Attach these fittings to the end of a screw jack to create pivoting connections with clevis rod ends and other linkages.
Add a flat mounting surface to to a screw jack to support loads.
Also known as machinery eyebolts.
Replace worn or broken caster axles.
Make your old puller work like new by replacing worn forcing screws.
Use adapters on the ends of forcing screws and face-grip puller legs when pulling shafts, bearing caps, and pinions.
Also known as transfer screws, these punches have a uniform shoulder height so you can quickly transfer multiple hole locations at once.